Assembly Section 2-6
ASSEMBLY
CABLE CONTROL MOUNTING BRACKET
Preassemble the cable control boxes to the control mounting bracket as shown in
the parts section. Use the image below for positioning the cable control
bracket. Position the support bracket on the floor as a template. The upper right
hole of the bracket is 2-1/2” from the right edge of the floor mat and 4” from the upper
lip of the mat as shown below. The upper left hole of the bracket is 5-5/8” from the
upper lip of the mat as shown below. Mark the holes on top of the floor mat. Be sure
that the location of the stand will allow clearance between the cable control box
handles and all existing interior levers, etc. Also watch out for wiring and brackets
when placing the bracket for drilling and cutting. Cut holes in the mat with a 1” hole
saw. The spacers provided are used to allow the cable control bracket to set on top
of the floor mat while being held securely to the floor of the cab. Drill 3 holes for the
capscrews using the bracket and spacers as a template. Then secure with the
hardware as noted in the parts section.
VALVE MOUNTING BRACKET
The valve mounts are made to fasten to the back fenders of the tractor. The top
rear hole on the mounting bracket match an existing hole on the fender. Ream out
the existing mounting holes to fit the 3/8” hardware. Attach the valve mounting plate
to the brackets. Next, attach the brackets to the fender by the rear holes, level the
valve mounting plate and mark the two remaining holes on each bracket. Drill the
four remaining 3/8” holes. Apply the hardware to the top two holes of the valve
mounting brackets and attach them to the fender.
The ends of the valve mount brace are threaded and the brace supports the lower
portion of the bracket. Refer to the parts section for the hardware used. Attach the
right lower hole of the bracket to the fender with the 3/8” capscrew, flatwasher and
hex nut. Thread the brace on to the end of the lower right capscrew. Attach the
other end of the brace to the fender and to the bracket with the other capscrew and
flatwasher.
EXISTING
HOLE
VALVE MOUNT
BRACE
HEX NUT
FENDER
RIGHT VALVE
MOUNTING
BRACKET
LEFT VALVE
MOUNTING
BRACKET