Tiger Products Co., Ltd M105X/S Maintenance Weekly or Every 50 Hours, Monthly or Every 150 Hours

MAINTENANCE

WEEKLY OR EVERY 50 HOURS

ITEM	SERVICE			COMMENTS
In Tank Hyd. Fluid	Change			Change after first 50
Filter				hours only, then every
(10 micron filter)				500 hours or yearly
In-Line High Pressure	Change			Change after first 50
Filter				hours only, then every
(10 micron filter)				500 hours or yearly
MONTHLY OR EVERY 150 HOURS
Hydraulic Fluid Level	Check			Add as needed
Hyd. Tank Breather	Clean / Check / Replace			Clean or replace
Rear Tire Type		Max P.S.I.		Element as required
480/80R38		29
18.4-34		26
18.4-38		26
YEARLY OR EVERY 500 HOURS
Spindle Grease	Change
Motor to Spindle Spline	Change
Hyd. Tank Fluid	Change
In Tank Hyd. Fluid Filter	Change
(10 micron filter)
In-Line HP Filter	Change		or	Change when indicated
(10 micron filter)				by restriction indicator.
Hyd. Tank Breather	Change
TROUBLE SHOOTING
SYMPTOMS		CAUSE		REMEDY
Vibration	1.	Loose bolts		1. Check all bolts and tighten
				to torque specs. in this section
	2.	Cutter assembly		2a. Check for damaged blades,
				disc. Unbalanced or cutter
				shaft. Replace if needed.
				2b. Check for wire, rope, etc.
				entangled in cutter assembly
Mower will not lift	1.	Hyd. Fluid low		1. Check and refill Hyd. Fluid.
	2.	Leaks in line		2. Tighten or replace fittings
				and hoses
	3.	Faulty relief valve		3. Check pressure in line. Line
				pressure in Control Valves
				should be at least 2500 P.S.I.
	4.	Kinked or blocked		4. Clean or replace lines
	5.	Faulty cylinder		5. Inspect, repair or replace
				cylinder

Maintenance Section 4-4