Tiger Products Co., Ltd M105X/S manual Do not put hands or feet under lifted components. S3PT-1

SAFETY

	SAFETY
WARNING!	Never leave the Tractor and Implement unattended while the Implement is
	in the lifted position. Accidental operation of lifting lever or a hydraulic
	failure may cause sudden drop of unit with injury or death by crushing.
	To properly park the implement when disconnecting it from the tractor,
	lower the stand and put the retaining pin securely in place, or put a secure
	support under the A-Frame. Lower the implement carefully to the ground.
	Do not put hands or feet under lifted components. (S3PT-1)

WARNING! Relieve hydraulic pressure prior to doing any maintenance or repair work on the Implement. Place the Mower Head on the ground or securely supported on blocks or stands, disengage the PTO, and turn off the engine. Push and pull the control Levers or Joystick several times to relieve pressure prior to starting any maintenance or repair

	work. (SBM-6)
DANGER!	Always disconnect the wire leads from the mower valve solenoid before
	performing service on the Tractor or Mower. Use caution when working
	on the Tractor or Mower. Tractor engine must be stopped before
	working on Mower or Tractor. The Mower Blades could inadvertently be
	turned on without warning and cause immediate dismemberment, injury
	or death. (SBM-12)
WARNING!	Use extreme care when lowering or unfolding the implement’s wings.
	Make sure no bystanders are close by or underneath the wings. Allow
	ample clearance around the implement when folding or unfolding the
	wings. Use extreme caution around buildings or overhead power lines.
	(S3PT-
	5)
WARNING!	Relieve hydraulic pressure prior to doing any maintenance or repair work
	on the Implement. Place the Implement on the ground or securely
	blocked up, disengage the PTO, and turn off the tractor engine. Push
	and pull the Remote Cylinder lever in and out several times prior to
	starting any maintenance or repair work. (S3PT-9)
DANGER!	This Implement is wider than the Tractor. Be careful when operating
	or transporting this equipment to prevent the Implement from running
	into or striking sign posts, guard rails, concrete abutments or other
	solid objects. Such an impact could cause the Implement and Tractor
	to pivot violently resulting in loss of steering control, serious injury, or
	even death. Never allow the Implement to contact obstacles. (S3PT-
	12)
DANGER!	The flail cutter shaft is designed for standard rotation(same rotation
	as the tractor wheel during forward travel). Never operate the cutter
	shaft in the reverse rotation. Operating this mower in reverse
	rotation may cause objects to be thrown out the front of the mower
	head.

Side Rtry Safety Section 1-10