
www.timex.com
The Automatic Collection
24 Hour Hand
Minute Hand
Hour Hand
1 2 3
Power Indicator
Calendar
HOW TO SET THE TIME
Unscrew crown all the way out and turn to correct time. Push crown in to restart.
Watches with date: Note correct time of day (A.M. or P.M.) for proper date function. (Please see illustration above for
HOW TO SET “FAST DATE”
I
14
I
1 2 3
14
NOTE: Date may need to be manually updated at the end of each month by fol- lowing above procedure (otherwise it will continue to 31 and then roll over to 01 each month).
HOW TO WIND YOUR WATCH
Turn crown in position 1 to begin winding clockwise.
POWER RESERVE
The watch is
The maximum power reserve is at least 36 hours. The power reserve indicator shows you how much power remains. You should wind your watch when the indicator hand is near “LOW”.
BRACELET ADJUSTMENT
Sliding Clasp Bracelet
Open locking plate. Move clasp to desired bracelet length. Exert pres- sure while holding locking plate and slide clasp back and forth until it engages in grooves on underside of bracelet. Press locking plate down until it snaps closed. Clasp can be damaged if excessive force is used.
Foldover Clasp Bracelet
Find spring bar that connects bracelet to clasp. Using a pointed tool (Fig. 1), push spring bar in and gently twist bracelet to disengage. Determine wrist size, then insert spring bar in correct bottom hole (Fig. 2). Push down on spring bar, align with top hole and release to lock in place (Fig. 3).
Fig. 1 | Fig. 2 | Fig. 3 |
BRACELET LINK REMOVAL
Removing Links: Place bracelet upright and insert pointed tool in opening of link. Push pin forcefully in direction of arrow until link is detached (pins are designed to be dif-
ficult to remove). Repeat until desired number of links are removed.
Reassembly: Rejoin bracelet parts. Push pin back into link in opposite direction of arrow. Press pin down securely into bracelet until it is flush.
SOLID LINK BRACELET
Removing Links: Using a very small screwdriver, remove screws by turning counterclockwise. Repeat until desired number of links are removed. Do not remove links adjacent to clasp.
Reassembly: Rejoin bracelet parts and insert screw in end of opening where it was removed. Turn screw clockwise until tight and flush with bracelet.
(continued on reverse)