Invacare 9000XT Recliner, 9000 XT, 9000 Series Adjusting Anti-Tippers, Installing Anti-Tippers

SECTION 8—ANTI-TIPPERS/WHEEL LOCKS

3.Measure the distance between the bottom of the anti‐tipper wheels and the ground/floor.

NOTE: A 1½ to 2‐inch clearance between the bottom of the anti‐tipper wheels and the ground/floor MUST be maintained at all times.

4.If the distance between the bottom of anti‐tipper wheels and the ground/floor is not 1½ to 2‐inches, adjust anti‐tippers. Refer to Adjusting Anti‐Tippers on page 81.

Anti-Tipper	Anti-Rattle
Wheels

Anti-Tipper

Release Buttons

Rear Frame

Tubing

FIGURE 8.1 Installing Anti-Tippers

Adjusting Anti-Tippers

NOTE: For this procedure, refer to FIGURE 8.2.

1.Press the release buttons on the wheeled portion of the anti‐tipper and slide it up or down to achieve the 1‐1/2 to 2‐inch clearance (Detail “A”).

2.Check to make sure that the release buttons are fully engaged in adjustment holes.

DETAIL “A”

Release Buttons

1½ inches	2 inches
DETAIL “B”

Anti-Tipper

Height

Anti-Tipper

Length

FIGURE 8.2 Adjusting Anti-Tippers

NOTE: Refer to Detail “B” in FIGURE 8.2 and to the following charts to ensure the correct anti‐tipper is installed on the wheelchair. Seat‐to‐floor heights are approximate depending on front caster size and type. Refer to Changing Seat‐to‐Floor Height/Seat‐to‐Floor Angle on page 29 for an explanation of frame times. Anti‐Tipper length measurement is taken with the extension tube in the longest position available.The anti‐tipper height measurement MUST be taken with the anti‐tipper on a flat surface.

9000 XT (SUPER LOW FRAME)

CASTER	SEAT-TO-FLOOR		ANTI-TIPPER	ON CHAIR	OFF CHAIR KIT NUMBER
SIZE	HEIGHT		LENGTH/HEIGHT
6-inch	13½ and 14½ inches		10½ / 2-inches	1360SH	1064520
		9000 XDT (ADULT TALL FRAME)
CASTER	SEAT-TO-FLOOR		ANTI-TIPPER	ON CHAIR	OFF CHAIR KIT NUMBER
SIZE	HEIGHT		LENGTH/HEIGHT
8-inch	17½ and 19½ inches		11-5/8 / 2-3/4-inches	1360A	1058752

Part No. 1076155 81 9000 Series