Invacare 9000 XT, 9000XT Recliner, 9000 SL Chart 15 Seat-to-Floor Height of 19½ inches and 6 Angle

SECTION 5—SEAT TO FLOOR

Refer to the following table to determine the obtainable seat‐to‐floor heights and seat‐to‐floor angles for 22‐inch rear wheels and 8‐inch front casters:

SEAT-TO-FLOOR	SEAT-TO-FLOOR	REFER TO
HEIGHT*	ANGLE
19½ inches	6°	Chart 15
18½ inches	3°	Chart 16
18½ inches	6°	Chart 17
17½ inches	0°	Chart 18
17½ inches	3°	Chart 19
17½ inches	6°	Chart 20

*NOTE: The seat‐to‐floor heights are based on urethane tires. If wheelchair is equipped with pneumatic (properly inflated) or solid rubber tires, add ¼ inch to the measurements listed above. These heights can vary +/‐ ¼ inch due to tire wear and manufacturing tolerances.

NOTE: Charts 15 to 20 apply to adult/hemi frame styles only. Refer to the charts for seat‐to‐floor height settings for adult/tall (Adult/Tall Frame Style on page 31) and super low frame styles (Super Low Frame Style on page 31) and Changing Seat‐to‐Floor Height on page 77 for recliner frame styles.

Chart 15 - Seat-to-Floor Height of 19½ inches and 6° Angle

REAR WHEEL POSITION			ANTI-TIP	FRONT CASTER
OFFSET AXLE OPTION		STANDARD	PART/MODEL	MOUNTING	ADJC CAM
			NUMBERS
FORWARD*	REARWARD			POSITION	POSITION
Hole 1	Hole 1		N/A On-Chair		Front
			1113766 Off-Chair
Hole 3	Hole 3
					Notch

*NOTE: This offset axle plate position requires the caster headtube to be leading to provide adequate tire clearance between the rear tire and the front caster. Refer to Converting from Trailing to Leading or Leading to Trailing Casters on page 27.

9000 Series 40 Part No. 1076155