Invacare 9000 XDT, 9000 XT, 9000XT Recliner Installing Anti-Tippers, Changing Seat-to-Floor Height

SECTION 7—RECLINER

8-inch Front Casters

SEAT-TO-FLOOR	FRONT CASTER	REAR	REAR WHEEL
HEIGHT	MOUNTING	WHEEL	MOUNTING
(INCHES)	POSITION	SIZE	POSITION
17½	Top	20-inch	N/A
18½	Middle	22-inch	N/A
19½	Bottom	24-inch	N/A
Rear Wheel			Fork Mounting
Mounting
			Positions
Positions

Top

Middle

Bottom

FIGURE 7.16 Changing Seat-to-Floor Height

Installing Anti-Tippers

NOTE: For this procedure, refer to FIGURE 7.17.

1.Install the anti‐rattles onto the rear frame tubes if not already in place.

DETAIL “A”

Release

Buttons

Rear Frame

Tubing

2.Position the anti‐tippers with the

anti‐tipper wheels pointing toward the ground/floor.

3.Press the release buttons.

4.Insert the anti‐tippers into the rear frame tubing until the bottom release button locks in place.

NOTE: Refer to the following charts to ensure the correct anti‐tipper is installed in the wheelchair. Seat‐to‐floor heights are approximate depending on front caster type. The anti‐tipper height measurement MUST be taken with the anti‐tipper on a flat surface.

Anti-Tipper

Wheels

Anti-Tipper

Anti-Rattle

DETAIL “B”

Anti-Tipper

Height

Anti-Tipper

Length

FIGURE 7.17 Installing Anti-Tippers

9000 Series 78 Part No. 1076155