SECTION
Chart 20 - Seat-to-Floor Height of 17½ inches and 6° Angle
REAR WHEEL POSITION | FRONT CASTER | ||||
OFFSET AXLE OPTION | STANDARD | PART/MODEL | MOUNTING | ADJC CAM | |
FORWARD* | REARWARD |
| NUMBERS | POSITION | POSITION |
|
| ||||
|
|
|
| ||
Hole 4 | Hole 4 |
| N/A |
| Front |
|
|
| |||
|
|
| 1113766 |
|
|
|
|
|
|
| |
Hole 3 | Hole 3 |
|
|
| Notch |
|
|
|
| ||
*NOTE: This offset axle plate position requires the caster headtube to be leading to provide adequate tire clearance between the rear tire and the front caster. Refer to Converting from Trailing to Leading or Leading to Trailing Casters on page 27.
WARNING
If changing the
Refer to the following table to determine the obtainable seat‐to‐floor heights and seat‐to‐floor angles for 22‐inch rear wheels and 6‐inch front casters:
REFER TO | ||
HEIGHT* | ANGLE |
|
|
|
|
17½ inches | 0° | Chart 21 |
|
|
|
17½ inches | 3° | Chart 22 |
|
|
|
17½ inches | 6° | Chart 23 |
|
|
|
16½ inches | 0° | Chart 24 |
|
|
|
16½ inches | 3° | Chart 25 |
|
|
|
16½ inches | 6° | Chart 26 |
|
|
|
15½ inches | 0° | Chart 27 |
|
|
|
15½ inches | 3° | Chart 28 |
|
|
|
*NOTE: The seat‐to‐floor heights are based on urethane tires. If wheelchair is equipped with pneumatic (properly inflated) or solid rubber tires, add ¼ inch to the measurements listed above. These heights can vary +/‐ ¼ inch due to tire wear and manufacturing tolerances.
NOTE: Charts 21 to 28 apply to adult/hemi frame styles only. Refer to the charts for seat‐to‐floor height settings for adult/tall (Adult/Tall Frame Style on page 31) and super low frame styles (Super Low Frame Style on page 31) and Changing Seat‐to‐Floor Height on page 77 for recliner frame styles.
Part No. 1076155 | 43 | 9000 Series |
