Invacare 9000 XDT, 9000 XT, 9000XT Recliner, 9000 Series, 9000 SL Permanent Axles, Detent Pin

SECTION 6—REAR WHEELS

5.If the detent balls are not protruding past the inside of the axle bushing or there is too much side‐to‐side movement of the rear wheel assembly, refer to the Owner’s Manual (part number 1056953) for instructions on adjusting the quick release axle.

DETAIL “A” - DETENT BALLS AND DETENT PIN

Axle Bushing

Detent Balls

Inside of

Wheelchair

Detent Pin	Outside of
	Wheelchair

Quick-Release Axle

Axle Mounting Positions

Axle Spacer (Conventional Arms Only)

Quick-Release Axle

Wheelchair Frame

Rear Wheel

FIGURE 6.1 Removing/Installing Rear Wheels - Quick-Release Axles

Permanent Axles

Models without Offset Axle Option

NOTE: For this procedure, refer to FIGURE 6.2.

NOTE: If replacing the same size rear wheel, note the mounting position on the wheelchair frame for proper reinstallation of the new rear wheel.

1.Remove the hub cap (if applicable), mounting screw and locknut that secure the rear wheel and axle spacer (if applicable) to the wheelchair.

NOTE: Axle spacer is used only if wheelchair is equipped with conventional arms.

2.To reinstall the rear wheel onto the wheelchair, reverse STEP 1.

3.Torque locknut to 40‐45 ft‐lbs.

4.Repeat STEPS 1‐3 for the opposite wheel.

Part No. 1076155 53 9000 Series