SECTION 7—RECLINER

Spring Grip

Fastener

Back Tube

Back Tube

Mounting Bracket

Swivel Nut

Cable

Assembly

 

STEPS 7, 10, 11, 13

Locknut

 

Locking

Mounting

Rod

Screw

Back Tube

Mounting Back Tube

Bracket

Clevis

Bracket

Mounting Screw

Locknut

FIGURE 7.7 Replacing Back Tube

Removing/Installing Spring Lift Mechanism

NOTE: For this procedure, refer to FIGURE 7.8.

Removing

1.Recline the wheelchair exposing the two (2) holes on either side of the spring lift mechanism.

NOTE: Before removing the spring lift mechanism, a retaining clip must be installed to prevent the spring lift mechanism from compressing. The retaining clip, part number 1021688, can be purchased from Invacare at the number listed on the back cover.

2.Position one (1) end of the retainer clip in each of the holes.

3.Return chair to upright position until top portion of lift mechanism rests on the retaining clip.

4.Remove the locknut that secures the top of the spring lift mechanism to the wheelchair frame.

5.Remove the mounting screw, spacer, and locknut that secures the bottom of the spring lift mechanism to the wheelchair frame.

6.Remove existing spring lift mechanism.

Part No. 1076155

67

9000 Series

Page 67
Image 67
Invacare 9000 Series, 9000 XT, 9000XT Recliner, 9000 XDT, 9000 SL service manual Removing/Installing Spring Lift Mechanism