Invacare 9000 Series, 9000 XT, 9000XT Recliner, 9000 XDT, 9000 SL service manual Pivot Link

SECTION 7—RECLINER

SEAT WIDTH	PIVOT LINK
14-INCH		x
	14-Inch	DO NOT use
16-INCH	16-Inch	18-Inch
		x
18-INCH
	DO NOT use
19-INCH	19-Inch
20-INCH	20-Inch
22-INCH
		22-Inch

10.Secure the pivot link to the crossbraces and wheelchair frame with the four (4) button screws and locknuts. Securely tighten.

11.Reinstall the two (2) button screws, locknuts and crossbrace saddle that secure the bottom of the new crossbrace to the wheelchair frame. Repeat for opposite crossbrace. Securely tighten.

NOTE: Position crossbrace saddle on wheelchair frame using the washer on the underside of the wheelchair frame as a reference. See Detail ʺAʺ of FIGURE 7.10 for proper positioning of the crossbrace saddle.

12.Install the new back and seat upholstery onto the wheelchair. Refer to Replacing the Headrest/Back Upholstery and Replacing the Seat Upholstery in the ownerʹs manual, part number 1056953.

NOTE: There are three (3) lengths of spreader bars‐one (1) for each of the following groupings: 14‐inch wide chairs, 16 to 19‐inch wide chairs, and 20, 22‐inch wide chairs. All spreader bars install in the same manner.

13.Install the correct length spreader bar for the desired chair width. Refer to Storing/Replacing the Spreader Bar in the ownerʹs manual, part number 1056953.

14.If applicable, reinstall the headrest upholstery. Refer to Replacing the Headrest/Back Upholstery in the ownerʹs manual, part number 1056953.

15.If applicable, reinstall the headrest pillow. Refer to Replacing the Headrest Pillow in the ownerʹs manual, part number 1056953.

9000 Series 72 Part No. 1076155