Invacare 9000XT Recliner, 9000 XT, 9000 Series Front Casters, Front Caster Mounting Adjustments

SECTION 4—FRONT CASTERS

SECTION 4—FRONT CASTERS

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise, injury or damage may occur.

Front Caster Mounting Adjustments

NOTE: For this procedure, refer to FIGURE 4.1.

1.Remove the hex screw, washers (if so equipped) and locknut that secure the front caster to the fork.

2.Reposition the front caster on the fork to the determined mounting hole. Refer to Changing Seat‐to‐Floor Height/Seat‐to‐Floor Angle on page 29 to determine front caster mounting hole for front caster size and seat‐to‐floor height.

3.Secure front caster to fork with existing hex screw and locknut. Securely tighten.

WARNING

Make sure both front casters are positioned in the same mounting hole before using the wheelchair. Otherwise, injury may result.

4. Repeat STEPS 1‐3 for the opposite front caster.

Fork	Locknut
Hex Screw
	Washer
Washer	Front
	Caster

FIGURE 4.1 Front Caster Mounting Adjustments

9000 Series 26 Part No. 1076155