Invacare 9000 Series, 9000 XT, 9000XT Recliner, 9000 XDT, 9000 SL Label Location, Important Notice

LABEL LOCATION

LABEL LOCATION

IMPORTANT NOTICE

The wheel locks on this wheelchair have been pre-set at the factory to comply with the Veterans Administration functional Standard 8320.01 of the Federal Register, paragraph

3.2.4.5.3.If these wheel locks do not meet your needs, follow instructions below.

!CAUTION

Any wheel lock adjustments should embed wheel lock shoe at least 1/8" into tire when locked (3/16" on pneumatic tires).

INSTRUCTIONS FOR WHEEL

LOCK ADJUSTMENTS

1.Loosen wheel lock mounting fastener, which runs through mounting bracket and frame.

2.Slide clamp toward rear wheel until wheel lock shoe is embedded into tire material at least 1/8" when handle is engaged to the lock position (3/16" for pneumatic tires).

3.Tighten mounting fastener to secure mounting bracket in desired location and recheck lock shoe embedding.

4.Inspect for correct locking action BEFORE actual use.

00078X021-0394

NOTE: On		WARNING
all adjustable	Refer to Owner's Manual
anti‐tippers	for proper anti-tipper
	setting.	1085379
		WARNING
	DO NOT OPERATE WITHOUT
	THE ANTI-TIP TUBES
	REV. 5/98	INSTALLED. P/N 60106X144

Models with

Quick-Release Axles Only

WARNING

DETENT BALLS MUST BE SECURE-

LY SEATED IN RECESSED AREAS

OF AXLE BUSHINGS. ENSURE

THAT PLUNGER PIN IN HEAD END

OF AXLE IS FULLY RELEASED.

KEEP DETENT BALLS CLEAN.

1001948

Crossmember

Lower

Frame

Tube

9000 XDT Only

9000 XT Recliner Models Only

	WARNING
DO NOT OPERATE WITHOUT
	THE ANTI-TIP TUBES
REV. 5/98	INSTALLED. P/N 60106X144

CAUTION

DO NOT recline without occupant. When the chair is not occupied the back will raise abrup- tly. Keep clear of the chair back when raising

or lowering to avoid injury. 1023096

CAUTION

SERVICE OF SPRING

LIFT MECHANISM TO

BE PERFORMED BY

PROPERLY TRAINED

AUTHORIZED SERVICE

PERSONNEL ONLY.

1022642

Part No. 1076155 7 9000 Series