SECTION 7—RECLINER
Installing
CAUTION
DO NOT remove the retaining clip before the spring lift mechanism is secured to the wheelchair. If the retaining clip is removed, the spring lift mechanism will compress. This will make the spring lift mechanism unusable.
NOTE: If installing a new spring lift mechanism, assembly is shipped with retaining clip attached.
1.Install spring lift mechanism.
2.Install the mounting screw, spacer, and locknut that secures the bottom of the spring lift mechanism to the wheelchair frame.
3.Install the locknut that secures the top of the spring lift mechanism to the wheelchair frame.
CAUTION
DO NOT overtighten the attaching hardware of the spring lift mechanism. Other- wise, damage may occur.
4.Tighten both locknuts from STEPS 2‐3 until one (1) to two (2) full threads are exposed.
5.Remove retaining clip.
NOTE: If retaining clip can not be removed, contact Invacare technical support at the number listed on the back cover.
6. Return wheelchair to normal position.
| Wheelchair Frame |
| Locknut |
Locknut |
|
Spacer | Spring Lift |
| Mechanism |
Mounting Screw | Retainer Clip |
| |
Holes for |
|
Retainer Clip |
|
FIGURE 7.8 Removing/Installing Spring Lift Mechanism
9000 Series | 68 | Part No. 1076155 |
