TOA Electronics SLDVT-40, SLDVT-35 Variable Flame Height Adjustment, SIT Millivolt, Gas Valve

Millivolt Appliances - Appliances with Millivolt systems will be fitted with the gas control valve shown in Figure 3.

Electronic Appliances - Appliances with electronic systems will be fitted with the electronic valve shown in Figure 4.

Millivolt Appliances - To light millivolt ap- pliances refer to Figure 2. Detailed lighting instructions are found on Pages 18 & 19 . Mil- livolt appliance lighting instructions may also be found on the pull out lighting instruction labels attached to the gas control valve.

Once the pilot is lit, the main burner may be turned ON and OFF using wall switch, remote control, optional on unit rocker switch (FRS), or wall thermostat. To operate: Toggle the switch between its ON and OFF positions.

If your millivolt appliance is equipped with an optional remote switch kit (wall switch, remote control, rocker switch, or wall thermostat) and the pilot is lit, the appliance main burner may be turned on and off using the optional switch.

Note: To prevent excessive resistance in burner circuit (which can cause burner operation prob- lems), only one burner control switch should be wired to valve.

Electronic Appliances -

To light electronic appliances refer to the detailed lighting instructions found on Pages 20 & 21 of these instructions. Electronic appliance lighting instructions may also be found on the pull out lighting instruction labels attached to the gas control valve.

5 Inch
Pipe Nipple	Gas Flex Line	Valve	Piezo	Spring Door Latch
Figure 2

Main Gas Control Knob						Gas Inlet
				OT
			IL
			P
T	O	N
		it			TH
O			WO L
L
I
P
	FFO		H I		TP
					TPTH		Gas
IN	OUT
	Manifold Pressure						Outlet
Inlet
	Port		Variable Flame
Pressure
Port			Height Adjustment			Terminals TPTH, TP & TH
Figure 3						SIT Millivolt	Gas Valve

If your electronic appliance is equipped with an optional remote wall switch or remote control kit the appliance main burner may be turned on and off with the wall switch or remote control.

If your electronic appliance is not equipped with a wall switch or remote control, the main burner must be turned off and on with a gas control switch located in some other location by the installer. Contact the installer for directions.

Variable Flame Height Adjustment

Pilot Stage

Terminal

Ground (TP)

TP

Gas Outlet

To Burner

Pressure-Tap (Inlet)

	IN
TH TP
LO	HI
TH	OUT
	VENT

Pilot Gas

Outlet

PILOT	Supply Gas
IN	Inlet

1. All millivolt appliances are equipped with a variable gas control valve. Flame height for these models may be adjusted through a range between fixed low and high settings while the appliance is in operation. Adjust the flame height as desired after lighting the appliance by rotating the variable adjustment control knob (HI/LO) located on the front of the valve (refer to Figures 3 & 4 ).

Burner Stage	Regulator	Pressure-Tap
Terminal	Mounting Screw	(Manifold)
Figure 4		Dexen Electronic Gas Valve

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.