Front Glass Enclosure Panel, Removal and Installation
WARNING: Do not operate appli- ance with the glass front removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service technician.
WARNING: Do not attempt to substitute the materials used on this door, or replace cracked or broken glass with any materials other than those provided by the appliance manufacturer.
WARNING: Handle this glass with extreme care! Tempered glass is susceptible to damage
–do not scratch or handle roughly while reinstalling the glass door frame.
WARNING: The glass door of this appliance must only be replaced as a complete unit as provided by the manufacturer. Do not attempt to replace broken, cracked or chipped glass separately.
WARNING: Do not attempt to touch the front enclosure glass with your hands while the fireplace is in use.
Removing Glass Enclosure Panels
(see Figure 5)
1.To access the glass door securing latches, first open the lower control compartment door (Figure 5 ) by lifting and pulling the bottom panel forward.
2.Pull the latches forward and down to release them from the door channel.
3.Pull the bottom of the door out a few inches and grasp it on the right and left. Gently lift to release the door from its channel above the door. Pull the door forward.
4.Retrieve the glass door. Visually inspect the gasket on the backside of the frame. Gasket surface must be clean, free of irregularities and seated firmly.
5.Position the door in front of the firebox opening with the bottom of the door held away from the fireplace (Figure 5 ). Hook the top flange of the door frame over the top of the firebox frame.
6.Let the bottom of the door frame swing gently in towards the fireplace ensuring that the gasket seats evenly as the door frame draws shut. Fasten the two latches located underneath the firebox floor to the door's
7.If desired, install the optional hood. Note the location of the three clips inside the top air channel above the door. The clips are equally spaced on the top surface of the air channel opening. Use a screwdriver to open the clips slightly if needed. Engage the back edge of the eyebrow into the clips to secure.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
|
| Header |
|
| Spacing |
|
| Guides |
|
| 5/8” |
|
| Nailing |
|
| Flange |
|
| 1/2” |
|
| Nailing |
|
| Flange |
Glass |
|
|
Door |
| Flush |
|
| |
| Glass Door | Nailing |
| Spring Latch | Flange |
Conrol |
|
|
Compartment |
|
|
Panel | Hood | |
| ||
Figure 5 - INSTALLING GLASS DOOR | ||
