Assembly Instructions
NOTE: Before each use, make sure the blender cord is unplugged and the Control Dial is in the (0) OFF position.
Blender
CAUTION: Use extreme care when handling the Blade Assembly. Do not touch the Blades with your fingers. The Blades are very sharp and can cause injury if touched.
1.Carefully place the Rubber Seal Ring over the Blade Assembly.
2.Turn the Blender Container upside down. Insert the Blade Assembly into the opening at the bottom of the Container, then turn the Collar clockwise to engage the threads.
3.The Blade Assembly MUST be firmly attached to the Blender Container, Note that the Measuring Cap doubles as a 'key' to tighten or loosen the Blade Assembly. Insert the Measuring Cap into the Collar, allowing the notches in the Measuring Cap to engage the ribs in the Collar. While secure- ly holding the Blender Container, turn the Collar clockwise to tighten or counter clockwise to loosen.
4.When tightening the collar align
the LOCK symbol molded on the bottom of the collar, within the LOCK RANGE symbol IIIIIII molded on the bottom of the Blending Container.
5.Place the Blender Container onto the Motor Housing, mak- ing sure it is properly seated.
Measuring | 60 |
| ml |
| 20 |
| 40 |
Cap 
max 1500 ml
| 1250 |
| 1000 |
Blender | 750 |
500 | |
Container | 250 |
Rubber
Seal
Ring
Blade 
Assembly 
Collar
Measuring Cap In Use As a Key
| ml |
| 20 |
Locking Notches | 40 |
60 |
Blade Assembly
and Seal Ring
| 250 |
|
| 500 |
|
| 750 |
|
| 1000 |
|
| 1250 |
|
ml | 1500 | max |
6