Chopper
1.Place the Chopper Container on the Gear Box and align the locking tabs. Hold the Gear Box and turn the Chopper Container clockwise to lock the two pieces together.
2.Place the Chopper Blade over the center extension in the Chopper Container.
3.Place the Chopper Cover on the Chopper Container, making sure that the pin extending down from the Chopper Cover enters the hole in the Chopper Blade. Press down on the Chopper Cover and turn it clockwise to engage the locking tabs.
4.Place the Chopper Assembly on the Motor Housing, making sure it is fully seated.
Chopper Cover
Chopper Blade
Chopper Container
Gear Box
Instructions For Use
Blender
CAUTION: Keep hands and utensils out of the Container while blending to prevent the possibility of severe injury to persons or damage to the unit. A scraper may be used but must only be used when the unit is not running.
CAUTION: Use extreme care when handling the Blender Blade Assembly. Do not touch the Blades with your fingers. The Blades are very sharp and can cause injury if touched.
1.Before starting, make sure power cord is unplugged and the Control Dial is in (0) OFF position.
2.Place the Motor Housing on a clean, dry surface to prevent debris being pulled into the motor during operation.
3.Make sure that the Blade Assembly, Rubber Seal Ring and Collar are properly assembled and securely fastened to the Blender Container. See Assembly Instructions for details.
4.Place the Blender Container on top of the Motor Housing, making sure it is firmly seated and not tilting to one side.
CAUTION: Never place the Blade Assembly on the Motor Housing without the Blender Container being completely assembled and securely tightened.
7