Top Innovations SF-850 Simultaneous Vacuum and Steam Functions, Blower Function, How to Use

Connecting the textiles tool (H) and Squeegee

(I)

ξ To clean armchairs, mattresses, and fabric surfaces, use the textile tool (H), using the steam function and then the vacuum function to vacuum up the steam and dirt. For the cleaning of glass and small hard surfaces, attach the squeegee (I) on the tool. Fig. 7, by sliding the squeegee on the tool.

Connecting the hose (E)

ξ Flip the accessory socket door (7) wide open and fit the quick connection of the hose (E) to the socket on the front of the appliance. Press the connection in as far as it will go.

ξ Close the accessory socket door (7) so that is rests on the body of the quick connection and check that the two elements are properly engaged. Fig. 8

Vacuum Cleaning Alone

ξ 5ch on the machine at the main switch

(3)and push vacuum On/Off button

(10).Fig. 9-10

ξ Adjust the vacuum suction on the panel control with buttons (14) (15) (Increase/Decrease vacuum suction) Fig. 10

ξ Push the vacuum function control button (G) on the handle of the work hose (E) to activate or deactivate the vacuum function. Fig 11

Steam Cleaning Alone

ξ Switch On button on the machine at the

main switch (3) and push the steam heating button (11). Once the ready light (13) illuminates, the steam is ready to use. Fig. 10

ξ Adjust the steam volume via the button (15) on the control panel (6). Fig 10

ξ Push the steam On/Off button (F) on the handle of the work hose (E), to activate or deactivate the steam function. Fig 11

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Fig. 11

Simultaneous Vacuum and Steam Functions

Note: With the multipurpose brush, you can clean and care for nearly all surfaces, such as tiles, parquet, PVC, stone floors linoleum, rugs, and carpets. With rugs and carpets, the pile is both straightened a new and cleaned. With rough floors, dirt is cleaned out of the depths and then vacuumed up. Sensitive materials (such as wool, velour, or waxed surfaces) absolutely must be tested for heat resistance in order to avoid damage.

Blower Function

With the Blower Function, air is blown out of the
machine allowing you to perform such tasks as
blowing fallen leaves in the garden and removing
dust from areas where the accessories cannot
reach.
How to Use:
ξ Remove the water tank and cover (1+2)
from the back of the unit. Fig 12.
ξ Remove the blower function cap. Fig. 13
ξ Connect the blower (M) into the intake hole;
push it in as far as it will go until snug. Fig.
14
	Fig. 12
ξ Turn Main Switch (3) on and push the
vacuum function button (10).
ξ Adjust the vacuum suction on the panel
control with buttons (14) (15)
(Increase/Decrease vacuum suction)
ξ Push the vacuum function control button (G)
on the handle of the work hose (E) to
activate or deactivate the blowing function,
the use of the hose (E) with nozzle (J) is
recommended. Fig 15.
	Fig. 13

8	Fig.15	Fig. 14
	9