HANDL. B1200C/1210C 30-03-2001 08:32 Page 50

Butler 1200C/1210C

4.2 Subscribing a handset to a Butler 1000, 1010, 1210 base unit

In order to be able to make and receive telephone calls, a new handset has to be subscribed to the base unit.

The underlined procedure is only applicable to a Butler 1000, 1010, 1210 handset and base unit!!

Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator

on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly for one minute. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the handset:

Press the Programming key .

Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.

Press the Programming key .

‘BASE _‘ appears on the display.

Enter a number of the base unit you would like to subscribe the handset to (1-4). Use the number keypad.

Note: Each handset can be subscribed to 4 different DECT base units. Each base unit is assigned a number from 1 to 4 in the handset. When you subscribe a new handset, you can assign a base unit number. It is best to use ‘1’ .

‘SEARCHING’ and the symbol appears on the display.

The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal sounds when the handset has found the base unit.

Press the Programming key .

‘PIN’ appears on the display.

Enter the 4-digit PIN code of the base unit in (default PIN code is ‘0000’). Use the number keypad.

Press the Programming key .

The handset is subscribed to the base unit.

4.3Subscribing Butler 1210C handset on Butler 575/575+ & Cocoon100/100+ & Butler 2000 base unit

Press the Paging key on the Butler 575/575+ or Cocoon100/100+ or Butler 2000 base unit for +/- 15 seconds until you hear a beep. The base unit is now in subscribing mode. For 1 minute, the base unit is in subscribing mode and you have to do the following to subscribe the handset:

• Press the Programming key .

• Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.

• Press the Programming key .

• ‘BASE _‘ appears on the display.

• Enter a number for the base unit to which you would like to subscribe the handset (1-4). Use the number keypad.

• ‘SEARCHING’ and the symbol appear on the display.

• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal sounds once the base unit is found by the handset.

50

Page 48
Image 48
Topcom 1200C, 1210C manual Subscribing a handset to a Butler 1000, 1010, 1210 base unit