30 Service Search
you had better check the receiving quality of every trans- ponder and choose the best one at the Transponder (or Frequency) option. It will be helpful to your fine tuning.
5.Finally set the Motor Control option to Store to save the tuned position when the receiving quality is best.
There are more motor control options for installers, but this guide does not describe them. If you are an installer, refer them to the manual about the STAB rotor.
4.1.3 Configuring USALS settings
USALS (Universal Satellite Automatic Location System), also known as DiSEqC 1.3, calculates the positions of all available satellites from your location. Compared to DiSEqC 1.2, it is no longer required to manually search and store every satellite position. Just pointing to a known satellite position is enough. This position will act as a central point. The USALS will then calculate positions of visible satellites.
To use the USALS protocol, se- lect the Installation > USALS Setting menu. You should see a screen like the left figure.
At first you have to set the Mo- torized DiSEqC 1.3 option to En- able.
To get every satellite position calculated, perform the following steps:
1.Choose your desired satellite at the Satellite Name op- tion.
