19.Slow down before turning. Operate the machine smoothly. Avoid erratic operation and excessive speed.

20.Disengage blade(s), set parking brake, stop engine and wait until the blade(s) come to a complete stop before removing grass catcher, emptying grass, unclogging chute, removing any grass or debris, or making any adjustments.

21.Never leave a running machine unattended. Always turn off blade(s), place transmission in neutral, set parking brake, stop engine and remove key before dismounting.

22.Use extra care when loading or unloading the machine into a trailer or truck. This unit should not be driven up or down ramp(s), because the unit could tip over, causing serious personal injury. The unit must be pushed manually on ramp(s) to load or unload properly.

23.Muffler and engine become hot and can cause a burn. Do not touch.

24.Check overhead clearances carefully before driving under low hanging tree branches, wires, door openings etc., where the operator may be struck or pulled from the unit, which could result in serious injury.

25.Disengage all attachment clutches, depress the brake pedal completely and shift into neutral before attempting to start engine.

26.Your machine is designed to cut normal residential grass of a height no more than 10”. Do not attempt to mow through unusually tall, dry grass (e.g., pasture) or piles of dry leaves. Dry grass or leaves may contact the engine exhaust and/or build up on the mower deck presenting a potential fire hazard.

27.Use only accessories and attachments approved for this machine by the machine manufacturer. Read, understand and follow all instructions provided with the approved accessory or attachment.

28.Data indicates that operators, age 60 years and above, are involved in a large percentage of riding mower-related injuries. These operators should evaluate their ability to operate the riding mower safely enough to protect themselves and others from serious injury.

29.If situations occur which are not covered in this manual, use care and good judgment. Contact a Toro Service Dealer for assistance.

SLOPE OPERATION

Slopes are a major factor related to loss of control and tip-over accidents which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it.

For your safety, use the slope gauge included as part of this manual to measure slopes before operating this unit on a sloped or hilly area. If the slope is greater than 15 degrees as shown on the slope gauge, do not operate this unit on that area or serious injury could result.

DO:

1.Mow up and down slopes, not across. Exercise extreme caution when changing direction on slopes.

2.Watch for holes, ruts, bumps, rocks, or other hidden objects. Uneven terrain could overturn the machine. Tall grass can hide obstacles.

3.Use slow speed. Choose a low enough speed setting so that you will not have to stop or shift while on the slope. Tires may lose traction on slopes even though the brakes are functioning properly. Always keep machine in gear when going down slopes to take advantage of engine braking action.

4.Follow the manufacturer’s recommendations for wheel weights or counterweights to improve stability.

5.Use extra care with grass catchers or other attachments. These can change the stability of the machine.

6.Keep all movement on the slopes slow and gradual. Do not make sudden changes in speed or direction. Rapid transmission engagement or braking could cause the front of the machine to lift and rapidly flip over backwards which could cause serious injury.

7.Avoid starting or stopping on a slope. If tires lose traction, disengage the blade(s) and proceed slowly straight down the slope.

DO NOT:

1.Do not turn on slopes unless necessary; then, turn slowly and gradually downhill, if possible.

2.Do not mow near drop-offs, ditches or embankments. The mower could suddenly turn over if a wheel is over the edge of a cliff, ditch, or if an edge caves in.

3.Do not try to stabilize the machine by putting your foot on the ground.

4.Do not use a grass catcher on steep slopes.

5.Do not mow on wet grass. Reduced traction could cause sliding.

6.Do not shift to neutral and coast downhill. Doing so may cause the operator to lose control of the machine resulting in serious injury or death.

7.Do not tow heavy pull behind attachments (e.g. loaded dump cart, lawn roller, etc.) on slopes greater than 5 degrees. When going down hill, the extra weight tends to push the tractor and may cause you to loose control. (e.g. tractor may speed up, braking and steering ability are reduced, attachment may jack-knife and cause tractor to overturn).

4

Page 3 Page 5
Page 4
Image 4
Toro LX500 manual Slope Operation
Page 3 Page 5

LX500 specifications

The Toro LX500 is a highly regarded riding lawn mower that combines power, comfort, and cutting-edge technology to deliver a premium lawn care experience. Designed for homeowners with medium to large yards, the LX500 stands out in the crowded market of garden equipment with its robust features and user-friendly design.

One of the main characteristics of the LX500 is its powerful engine. It typically comes equipped with a reliable 500cc engine, providing more than enough power for tackling tough mowing tasks. The engine is designed for durability, ensuring longevity and efficient performance. Its high output allows users to handle even overgrown grass with ease, making it a versatile option for various lawn conditions.

The cutting deck of the Toro LX500 offers a generous cutting width, often around 50 inches, which enables users to cover more ground in less time. The deck is crafted from high-quality materials, ensuring durability as well as superior cut quality. With multiple cutting height adjustments, users can customize the mower to achieve the desired grass length, enhancing their lawn’s appearance.

Comfort is a significant focus in the design of the LX500, as it features an ergonomic seat equipped with armrests and adjustable settings. This emphasis on user comfort allows for longer mowing sessions without fatigue. Additionally, it incorporates a smooth steering system, making maneuvering around obstacles and tight spaces less challenging.

The Toro LX500 also incorporates advanced technologies, such as the Smart Speed control system, allowing users to adjust the speed of the mower based on the task at hand. This feature ensures maximum efficiency whether mowing, towing, or handling other yard tasks. Furthermore, the mower is designed for easy maintenance, with accessible components for oil changes, filter replacements, and blade sharpening.

Another notable feature is the inclusion of a washout port for the mower deck, which simplifies the cleaning process and helps maintain performance. This ensures that grass clippings and debris don’t accumulate, leading to a clean cut every time.

Overall, the Toro LX500 represents a well-balanced combination of power, efficiency, and comfort, making it a worthy investment for anyone looking to maintain a beautiful lawn efficiently. With its robust features and user-focused design, it is poised to meet the demands of modern lawn care.
Top Page Image Contents