Toshiba 1202kit installation instructions DVD-RAM Front Panel, DVD-RAM Back Panel

DVD-RAM FRONT PANEL

The photo below illustrates the following features of the SD-W2002 DVD-RAM’s front panel:

Emergency Eject Hole: The emergency eject hole is to be used only when the DVD tray will not open when the Load/Unload button is pressed. Insert solid bar (i.e. paper clip) into hole, applying gentle presure, until tray opens. Do not use Emer- gency Eject Procedure while the drive is in operation.

Loading Tray: Load disc using tray or recording cartridge

Load/Unload Button: Used to open the disc tray so you can install or remove a disc or recording cartridge.

Busy Indiactor: Provides status of drive.

DVD-RAM BACK PANEL

The photo below illustrates the following features of the SD-W2002 DVD-RAMs back panel:

Digital Audio Out Connector: Outputs Digital Audio on the DVD-RAM.

Analog Audio Out Connector: Outputs Analog Audio on the DVD-RAM.

ATAPI Connector: Connects DVD-RAM to computer.

Power Connector: Connects DVD-RAM to power source.

Mode Select Jumper: Selects if drive is to be Master, Slave or Cable Select.

6