20
Using the remote
control
To control a DVD player:
Program the remote control to recognize the brand of your
DVD player (see Programming the remote control to operate
your other devices below).
The buttons shown at right will then control the DVD player.
Press DVD first.
Programming the remote control to operate your other devices
This remote control is pre-programmed to operate most
Toshiba satellite receivers, VCRs, and DVD players. To
control a non-Toshiba device (or a Toshiba device that the
remote control is not reprogrammed to operate), you must
follow the steps below to program your remote control.
1. Refer to the code tables (on pages 21 and 22) to find the
corresponding code for your device.
If more than one code is listed, try each one separately
until you find the one that works.
2. If you are programming the remote control to operate
your:
• Cable TV converter/satellite receiver: Press CBL/SAT.
• VCR: Press VCR.
• DVD player: Press DVD.
3. While holding down DISPLAY, press the Channel
Number buttons to enter the three-digit code for your
device within 10 seconds.
Note: If you do not enter the code within 10 seconds from step 3, or if
you enter the wrong code, this operation is canceled.
4. Point the remote control at the cable TV converter/
satellite receiver, VCR or DVD player, and press POWER
to test the code.
• If the device responds, you entered the correct code.
• If the device does not respond, repeat ste ps 1–4 using
another code.
5. Press TV to control the TV.
For future reference, write down the codes you used:
Cable TV converter/satellite receiver code
VCR code
DVD player code
Note:
• When shipped from the factory, the remote control is set to operate
your TV.
• Each time you replace the batteries, you must reprogram the remote
control.
• Some newer VCRs are capable of working on either of two remote
codes. These VCRs have a switch labeled VCR1/VCR2.
If your VCR has this kind of switch and does not respond to any of the
codes for your VCR, set the switch to the other position (VCR1 or
VCR2) and reprogram the remote control.
MUTE
POWER
INPUT
Number
buttons
VOL+-
DVD
PIC SIZE
STWX
DVD MENU
ENTER
DVD controls
CLEAR
TOP MENU
DISPLAY
Channel
Numbers
DISPLAY
TV
VCR
DVD
CBL/SAT
DVD SKIP/SEARC
H