Toshiba 32FT2U owner manual Setting the sleep timer, Automatic Power Down, No Signal Power Down

Chapter 6: Using the TV’s features

Setting the sleep timer

You can set the sleep timer to turn off the TV after a set length of time (maximum of 12 hours).

To set the sleep timer using the remote control:

Press on the remote control to set the length of time until the TV turns off. Repeatedly press to increase the time in 10-minute increments, or press

or  to increase or decrease the time in 10-minute increments, to a maximum of 12 hours.

To set the sleep timer using the on-screen menus:

1無 Press and open the Setup menu.

2無 Highlight Sleep Timer and press .

3無 Press the Number button to enter the length of time in 10-minutes increments.

4無 Press .

Note: When a power failure occurs, the sleep timer setting may be cleared.

To display the remaining sleep time:

Press .

To cancel the sleep timer:

Press repeatedly or press  or  until it is set to 0 minutes.

Automatic Power Down

The TV will automatically turn itself off (standby) after 4 hours, if you do not operate the TV either from the remote control or the TV control panel.

1無 From the Preferences menu, highlight Energy

Saving Settings and press .

2無 Press  or  to select Automatic Power Down. 3無 Press  or  to select On or Off, and press .

Note:

•The default setting of this feature is Off.

•1 minute before switching to standby, a warning message will appear.

•When the following features are set, the feature that is set for the nearest time will function.

−−Automatic Power Down

−−Sleep Timer

−−No signal auto power off (after 15 minutes of no signal)

No Signal Power Down

The TV will automatically turn itself off after 15 minutes when no signal is detected.

You can change the setting to Off for the following purposes:

•Low signal strength of analog channel (no signal detection.)

•Only Audio L/R is connected to external input to listen to music through the TV speakers.

1無 From the Preferences menu, highlight Energy

Saving Settings and press .

2無 Press  or  to select No Signal Power Down

and press .

3無 Press  or  to highlight the item you want to change, and press  or  to select On or Off.

Note:

•The default setting of this feature is On.

•A warning message will appear 1 minute before turning off.

(continued)

46