Confirming Print Job Status 287

USB print
This function allows you to print files stored in a USB device connected to the connector for USB
storage device of this equipment. In this function only PDF and Encrypt PDF files (with an exten-
sion “.pdf”), XPS files (with an extension “.xps”) or JPEG files (with an extension “.jpg” or “.jpeg”)
can be printed.
yIt may take a long time to perform USB printing or cancel it compared to normal printing from
a PC. We recommend normal printing when you print a large number of pages.
yThe print range cannot be set. The whole page is printed.
yPDF file versions 1.3 to 1.6 are supported.
yThe Encrypt PDF function is supported for PDF files whose version is 1.3 or 1.4.
yDo not turn the power of the equipment ON while the USB device is connected to the con-
nector for the USB storage device.
yThe USB storage device shall meet the following condition.
- FAT16 and FAT32 formats
- Single-partition (Plural-partition USB devices cannot be used.)
- Maximum memory capacity: 2GB
Displaying USB print job list
1

Connect the USB device to the

connector for USB storage

device.

After a few seconds, “FOUND USB
DEVICE” appears in the upper right part
of the screen.
Removing USB device
Check that “USB DEVICE in use Do not
remove USB DEVICE” is not appearing.
Do not disconnect the USB device while
this message is displayed. This could
destroy data in the USB device or cause
a malfunction in this equipment.
2

Press the [JOB STATUS] but-

ton on the control panel.

The print job list is displayed.