Using the Remote Control
Using the remote control
Preparing the remote control for use
The remote control will operate your TV, most VCR models, and most cable TV converters together, even if they are different brands.
¥If you will be using your TV with a Toshiba VCR or cable TV converter, your remote control is already programmed and ready to use. See ÒUsing the remote control with a VCR or cable TV converterÓ below.
¥If you own a
Installing the remote control batteries
To install the batteries:
1. Slide the battery cover off the back of the remote control.
Note:
The remote control provided with your TV may or may not operate certain features on your VCR, cable TV converter, or other electronic equipment. Refer to the ownerÕs manuals provided with your other equipment to see which features are available. In addition, the other remote controls may have buttons not available on your TVÕs remote control. If you would like to use those features or buttons, you may need to use the original remote controls provided with your other equipment.
Caution:
¥Dispose of batteries in a designated disposal area. Do not throw batteries into a fire.
¥Do not mix battery types or combine used batteries with new ones.
¥Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment.
¥If you do not intend to use the remote control for a long time, remove the batteries.
2.Install two ÒAAÓ size batteries. Match the + and Ð symbols on the batteries to the symbols on the battery compartment.
3.Slide the battery cover back onto the remote control until the lock snaps.
Using the remote control with a VCR or cable TV converter
To control a VCR:
Set the TV/CABLE/VCR switch to the VCR position. The shaded buttons in the illustration at right will then control the VCR. The unshaded buttons will operate the TV as usual.
To control a cable TV converter:
Set the TV/CABLE/VCR switch to the CABLE position. The shaded buttons in the top portion of the illustration at right will then control the cable TV converter.
LIGHT RECALL POWER
TV |
| |
CABLE | MUTE TV/VIDEO TIMER | |
VCR | ||
|
1 | 2 |
| 3 |
|
|
| CH |
4 | 5 |
| 6 |
7 | 8 |
| 9 |
|
|
| VOL |
|
| CH RTN | |
100 | 0 | ENT | |
|
| ADV/ |
|
.CAPT | PIP CH | MENU | |
|
| ||
C |
|
|
|
FAV | ENTER | FAV | |
RESET |
| ADV/ | EXIT |
|
| ||
| PIP CH |
| |
STOP SOURCE | PLAY PIP | ||
REC TV/VCR REW FF
STILL LOCATE SWAP
RECALL
POWER
TV/CABLE/VCR switch
CH (Channel) 
Channel
Numbers
ENT (used for the “ENTER” command with some VCRs and cable TV converters)
STOP
PLAY
FAST FORWARD
REWIND
TV/VCR
RECORD
12
