PAGE 58
Remote control doesn’t work.
Menu options can’t be
changed or selected.
No picture or sound
when any non-cable source
is selected.
Weak or no Stereo Sound
when using a stereo VCR.
The PIP inset is black or
lacks contrast.
The PIP inset is “snow” when
the source is Antenna.
Time is incorrect.
Picture Interference
Troubleshooting (Contd.)•Make sure the batteries are fresh and installed properly.
•Try unplugging your TV for a few minutes,
then plug it back in.
•Check to see if the source equipment has been turned on.
•Make sure that the connections are secure on the back of your TV and on the
source equipment.
•Check to see if all the connections are secure.
•Look in the Audio mode menu to see if all the settings are correct.
•You are using channel 3 or 4 to view your VCR. No stereo sound is present
under that decision.
•Check to be sure that the PIP source is turned on.
•You might want to adjust the PIP picture settings under the PIP menu.
•Check that all the wires are connected properly.
•Check to see if your input source for PIP is set correctly.
•Look to see if the TV/VCR button on your VCR has the TV selected or change
the PIP to another source.
•Reset clock manually.
•Even though you may be getting cable service, the signal may be weak, which
means the quality of your picture may suffer due to other factors. If there are
problems with the image on your TV, consult the Troubleshooting guide on the
following pages. You may also want to contact your cable service provider to
determine if the problem is from the cable service.