Toshiba 2XF550U, 46XF550U Setting the Channel Tuning Mode, Tuning to the next programmed channel

Chapter 6: Using the TV’s features

Adding and clearing channels and inputs in the History List

Adding channels and inputs to the History List:

As a channel or input is tuned, the Channel Browser™ adds it to the History List and displays it on the “right side” of the Channel Browser™. Previously tuned channels/inputs are “shifted” to the left, eventually moving off the left side. Press 3 C to surf backward through the previously tuned channels/ inputs. Any channel or input that is tuned repeatedly will not be repeated in the History List, but instead is moved to the end of the list on the right side of the Channel Browser™.

The Channel Browser™ will store the following channels:

•All channels that are tuned using the numeric buttons on the remote control.

•All channels that are tuned using <or ,on the remote control.

Note: Whenever an item is selected that cannot be tuned (for various reasons), the TV will automatically tune to the previously viewed channel or input.

Clearing channels from the History List:

•Reconfiguring the ANT/CABLE input will clear the History List.

Note: See page 36 for details on configuring the antenna input.

•Once 32 channels or inputs are stored in the History List, the oldest item will be removed from the list when a new channel or input is tuned.

•Turning off the TV will clear the History List.

Setting the Channel Tuning Mode

This feature allows you to choose how tuning will be handled for analog and digital channels when the TV is in Antenna mode.

Note: To use this feature, the Input Configuration must be set to Antenna (- page 36).

The channel tuning mode has three options.

Mode	Description
Standard	Both analog and digital channels can be
	tuned normally
	Digital channels will have priority when
Auto	manually entering a channel number using
	the Channel Number (0-9) on the remote
(default)
	control, analog channels can still be tuned by
	</ ,if available
Digital	Only digital channels can be tuned

Note: Digital mode will be most useful after analog channels are shut down by the government in 2009.

To set the Channel Tuning Mode:

1 From the Setup menu, highlight Installation and press T. A new set of Installation menu icons will appear.

2 Open the Terrestrial menu, highlight Channel Tuning Mode, and then press c and B b to select your desired mode, and press T.

Note:

•The Channel Add/Delete & Channels Block windows as well as the Channel Browser ANT/CABLE list will be updated automatically when you change the mode. Also, the History List will be cleared, but the Favorites List will be saved.

•Even if the Channel Tuning Mode is set to Digital, analog channel 3 will still be the default channel to prevent the initial case where no digital channels have been found in prior channel scans. (Channel Add/Delete will not have anything listed until a scan is done.)

Tuning to the next programmed channel

To tune to the next programmed channel:

Press <or ,on the remote control or TV control panel.

Note:This feature will not work unless you program channels into the TV’s channel memory (- page 36).

Tuning to a specific channel (programmed or unprogrammed)

Tuning analog channels:

Press the Channel Number (0–9) on the remote control. For example, to select channel 125, press 1, 2, 5, then T.

Tuning digital channels:

Press the Channel Number (0–9) on the remote control, followed by the dash (=) button and then the sub-channel number. For example, to select digital channel 125-1, press 1, 2, 5, –, 1, then T.

Note: If a digital channel is not programmed—either through the automatic channel scan (- page 36) or the channel add/ delete function (- page 37)—you will have to tune the RF channel using the Channel Number and dash (=) on the remote control.

44