Getting started
Turning the TV on
Switching on the TV
Connect the power cord to a wall outlet, the ! power indicator lights in red (standby mode).
1Press 
on the remote control or ! on the TV right side panel, the ! power indicator lights in green.
Note:
If you watch black and white programs when the color system mode is set to Auto, color noise may appear on the screen. In this case select the appropriate Color system (For the system of each country or region, refer to pages 15 and 41).
Switching off the TV
1Press 
on the remote control or ! on the TV right side panel to switch to the standby mode.
Notes:
•This TV is not fully disconnected from the main supply, as minute current is consumed even when ! is turned off. When the TV will not be used for a long period of time, such as during vacation or travel, remove the power plug from the wall outlet.
•The TV will automatically turn itself off after approximately 15 minutes if it is tuned to a vacant channel or a station that completes its broadcast for the day. This function does not work in external input or Blue screen Off mode.
The TV will automatically turn itself off after approximately 2 hours if you do not operate the TV after turned on by on timer function.
•If power is cut off while you are viewing the TV, the Last Mode Memory function turns on the TV automatically when power is applied again. If power is going to be off for a long time and you are going to be away from your TV, unplug the power cord to prevent the TV from turning on in your absence.
Tuning the TV for the first time
- digital only -
Before switching on the TV, put your decoder and media recorder to Standby if they are connected and ensure the antenna is connected. To setup the TV use the buttons on the remote control as detailed on page 10.
1Press 
, the Welcome screen will appear. This screen will appear the first time that the TV is switched on and each time the TV is reset.
Thank you for choosing TOSHIBA television.
First you need to tune in your television.
Please ensure aerial is connected before proceeding.
Press 
to continue.
2Press Q to proceed.
3The Select Location screen will appear. Press or to select the state in which you live.
Select Location
Australian Capital Territory
New South Wales
Northern Territory
Queensland
South Australia
Tasmania
Victoria
Western Australia
MENU Back Select Function | EXIT Watch TV |
4Press Q to start tuning. The Auto Scan screen will appear and the TV will automatically start to search for available stations. The progress bar will move along the line.
Auto Scan
Channel 6 found...
|
| 7 Digital | ||
|
|
|
|
|
|
|
|
|
|
| 7 | Digital HD | ||
|
|
|
|
|
|
|
|
|
|
| 7 | Digital 1 | ||
|
|
|
|
|
|
|
|
|
|
| 7 | Digital 2 | ||
|
|
|
|
|
|
|
|
|
|
| 7 | Digital 3 | ||
|
|
|
|
|
|
|
|
|
|
|
| 7 | Digital Guide | |
|
|
|
| |
Scan Status | 6/69 | |||
Scan Percentage
Back 
Select Function
NT
Watch TV
5When the search is completed, the TV will automatically tune to the lowest logical channel number. See the following for more details on Auto Scan.
Note:
If you do not live in Australia, press P at the Select Location. Press M, then press or to select PROFILE.
Press or to select Time Zone to set your time zone (- page 24).
Then use Manual Scan to start tuning (- page 14).
11
