Toshiba 72HM195, 62HM195 Understanding the auto power off feature, Using the Gray Level feature

Chapter 8: Using the TV’s features

Displaying TV setting information on-screen using RECALL

To display TV setting information on-screen:

Press RECALL on the remote control. The following information will display on-screen (if applicable):

•Current input (ANT 1, ANT 2, VIDEO 1, etc.)

•If ANT 1 or ANT 2 is the current input, whether it is Cable TV (“CABLE”) or off-air (“TV”)

•	Channel number (if in	STEREO		Tuner Hold: On
	ANT 1 or ANT 2 mode)	NC-17
•	Signal strength indicator
		On Timer: Weekdays 12:00pm
	(bar graph in lower right	Game Timer: 28 min.
		Sleep Timer: 18 min.
	corner of screen; for			ANT 1
	ATSC signal only)	Natural		CABLE 81-1
		1080i	5:32pm

Note: The signal strength	Sample RECALL screen
indicator will react to fading
and increasing signals.

•Time (if set)

•On/Off timer settings (if set)

•Remaining time on sleep timer (if set)

•Remaining time on game timer (if set)

•Stereo or SAP audio status

•V-Chip rating status

•Picture size

•Tuner hold* (if applicable)

* If you are recording on one tuner (for example, the digital tuner), you will be able to change channels on the other tuner only (the analog tuner in this example). The tuner from which you are recording is Òon holdÓ (i.e., locked) so your recordings will not be affected by channel changes.

•Video resolution

•Lamp mode (appears only if the TV is in High Bright mode)

To close TV setting information on-screen:

Press RECALL again.

Understanding the auto power off feature

The TV will automatically turn itself off after approximately 15 minutes if it is tuned to a vacant channel or a station that completes its broadcast for the day. This feature functions in ANT 1 and ANT 2 modes only.

Understanding the last mode memory feature

If the power is cut off while you are viewing the TV, the Last Mode Memory feature automatically turns on the TV when the power is resupplied.

NOTE: You should unplug the TVÕs power cord if it is possible that you will be away from the TV for an extended period of time after the power is restored.

Using the Gray Level feature

The gray level feature will set the sidebars to three different levels of darkness. Sidebars are the blanks spaces on either side of a 4:3 viewing area.

To set the gray level of the sidebars:

1.Press MENU and open the Setup menu.

2.Highlight Gray Level and press •.

3.Press y or zto select your desired level of darkness (1 – Black, 2 – Dark Gray or 3 – Gray).

Setup

Sleep Timer			1
On/Off Timer			2
HDMI 1 Audio		Auto	3
HDMI 2 Audio		Auto
Slide Show Interval		2 Sec
AVHD Skip Time		15 min
Gray Level	2
Navigate	Select CH RTN Back		EXIT Exit

Note:

¥The gray level feature does not affect video being viewed in 16:9 aspect ratio.

¥When receiving a signal that has sidebars (e.g., 4:3 aspect ratio video over a 1080i or 720p signal), the gray level feature will not be applied to the sidebars.

92		Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
#01E_087-092_566272HM195	92	7/28/05, 5:00 PM

Black

(E) 56/62/72HM195