Toshiba A110 user manual Notes for use of this device in New Zealand

Notes for use of this device in New Zealand

■The grant of a Telepermit for a device in no way indicates Telecom acceptance of responsibility for the correct operation of that device under all operating conditions. In particular the higher speeds at which this modem is capable of operating depend on a specific network implementation which is only one of many ways of delivering high quality voice telephony to customers. Failure to operate should not be reported as a fault to Telecom.

■In addition to satisfactory line conditions a modem can only work properly if:

a/ it is compatible with the modem at the other end of the call and

b/ the application using the modem is compatible with the application at the other end of the call - e.g., accessing the Internet requires suitable software in addition to a modem.

■This equipment shall not be used in any manner which could constitute a nuisance to other Telecom customers.

■Some parameters required for compliance with Telecom's PTC Specifications are dependent on the equipment (PC) associated with this modem. The associated equipment shall be set to operate within the following limits for compliance with Telecom Specifications:

a/ There shall be no more than 10 call attempts to the same number within any 30 minute period for any single manual call initiation, and

b/ The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next.

c/ Automatic calls to different numbers shall be not less than 5 seconds apart.

■Immediately disconnect this equipment should it become physically damaged, and arrange for its disposal or repair.

■The correct settings for use with this modem in New Zealand are as follows:

ATB0 (CCITT operation) AT&G2 (1800 Hz guard tone)

AT&P1 (Decadic dialling make-break ratio =33%/67% ATS0=0 (not auto answer)

ATS10=less than 150 (loss of carrier to hangup delay, factory default of 15 recommended)

ATS11=90 (DTMF dealing on/off duration=90 ms)

ATX2 (Dial tone detect, but not (U.S.A.) call progress detect)

■When used in the Auto Answer mode, the S0 register must be set with a value of 3 or 4. This ensures:

(a)a person calling your modem will hear a short burst of ringing before the modem answers. This confirms that the call has been successfully switched through the network.

(b)caller identification information (which occurs between the first and second ring cadences) is not destroyed.

10 Satellite A110/Satellite Pro A110