2. PRINTER SETUP EO1-33030
2.10 Program Download
2- 28
2.10.6 Test Print
This procedure will be used to perform a test print.
1. To perform this operation, you will need to turn on the power of the
B-419 printer (do not hold the feed key this time). Connect the
printer to the PC with the RS-232C cable. Select the TPCL-LE
mode for the printer issue mode. Then set the communications
parameters as follows:
19200 bps, None parity
2. From the Install Program for B-419 main menu, select Options (O)
and Test Print (T) as shown in the screen display of the figure below.
3. When the following screen display appears, set the Label Pitch, Print
Count, and the Sensor, then click on the OK button.
A few seconds later, the printer will start the test print.
NOTES:
1. The default settings are:
Label Pitch: 127 mm
Print Count: 1
Sensor: Reflective
2. The size of the print image
for the test print has been
designed to fit to a 127 mm
pitch label. Therefore,
when using the paper of
shorter pitch, the print
image will breaks, or when
using the label of longer
pitch, a blank space will
remain.
3. Setting the different label
pitch from actual paper size
or using the paper with a
black mark printed on an
improper position may
cause an error.
Reflective