TROUBLESHOOTING
■Remote control
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
|
|
|
| |
The remote control | Wrong distance or angle. | The remote control will function within a maximum |
| |
does not work or |
| range of 6 m and no more than 30 degrees | 5 | |
function properly. |
| from the front panel. |
| |
|
|
|
| |
| Direct sunlight or lighting (from an | Reposition this unit. |
| |
| inverter type of fluorescent lamp, etc.) is |
| — | |
| striking the remote control sensor of this |
| ||
|
|
| ||
| unit. |
|
| |
|
|
|
| |
| The batteries are weak. | Replace all batteries. | 4 | |
|
|
|
| |
| AMP/SOURCE/TV is set incorrectly. | Set AMP/SOURCE/TV correctly. |
| |
|
| When operating this unit, set it to the AMP position. |
| |
|
| When operating the component selected by the input | — | |
|
| selector button, set it to the SOURCE position. | ||
|
|
| ||
|
| When operating the TV set in the DTV or PHONO |
| |
|
| area, set it to the TV position. |
| |
|
|
|
| |
| The remote control code was not correctly | Set the remote control code correctly using |
| |
| set. | “LIST OF REMOTE CONTROL CODES” at the end | 98 | |
|
| of this manual. |
| |
|
|
|
| |
|
| Try setting another code of the same manufacturer |
| |
|
| using “LIST OF REMOTE CONTROL CODES” at | 98 | |
|
| the end of this manual. |
| |
|
|
|
| |
| The library code of the remote control and | Match the remote control ID of this unit with the |
| |
| the remote control ID of this unit do not | corresponding remote control library code. | 95, 98 | |
| match. |
|
| |
|
|
|
| |
| Even if the remote control code is | Program the necessary functions independently into |
| |
| correctly set, there are some models that | the programmable buttons using the Learn feature. | 100 | |
| do not respond to the remote control. |
|
| |
|
|
|
| |
| The batteries do not last long and get | Using alkaline batteries is strongly recommended. | — | |
| quickly exhausted. |
| ||
|
|
| ||
|
|
|
| |
The remote control | The batteries of this remote control and/or | Replace the batteries. | 4 | |
does not learn new | the other remote control are too weak. |
| ||
|
| |||
functions. |
|
|
| |
The distance between the two remote | Place the remote controls at the proper distance. | 100 | ||
| ||||
| controls is too much or too little. |
| ||
|
|
| ||
|
|
|
| |
| The signal coding or modulation of the | Learning is not possible. |
| |
| other remote control is not compatible |
| — | |
| with this remote control. |
|
| |
|
|
|
| |
| Memory capacity is full. | Delete other unnecessary functions to make room for | 105 | |
|
| the new functions. | ||
|
|
| ||
|
|
|
|
118
