Yamaha RX-V2600 Setting remote control AMP codes, Setting remote control tuner codes, Press ENTER

Setting remote control AMP codes

Select one of the following codes to set the remote control AMP code for the component you want to use.

Set AMP/SOURCE/TV to AMP or SOURCE and then change the remote control code settings.

AMP library		Remote
code	Function	control
(remote		AMP ID (this
control		unit’s setting:
setting)		see page 95)
	To operate this unit using
2001	the default code.	ID1
(initial setting)	To operate Zone 2 or Zone 3	(initial setting)
	features (see page 108).
	To operate this unit using an
2002	alternative code.	ID2
	To operate Zone 2 or Zone 3
	features (see page 108).

Notes

•You need to set the corresponding remote control AMP ID (see page 95).

•When using multiple YAMAHA receivers/amplifiers, you may be able to operate the other components simultaneously with the default code setting. In this case, set one of the alternative codes to operate this unit separately.

Setting remote control tuner codes

Select one of the following codes to set the remote control tuner code for the component you want to use.

Set AMP/SOURCE/TV to SOURCE and press TUNER on the remote control to select TUNER as the input source and then change the remote control code settings.

Tuner		Remote
		control
library code
	Function	tuner ID
(remote
		(this unit’s
control
		setting:
setting)
		see page 95)
2602	To operate this unit using	ID1
(initial setting)	the default code.	(initial setting)
2603	To operate this unit using an	ID2
	alternative code.

Notes

•You need to set the corresponding remote control tuner ID (see page 95).

•When using multiple YAMAHA receivers/amplifiers, you may be able to operate the other components simultaneously with the default code setting. In this case, set one of the alternative codes to operate this unit separately.

REMOTE CONTROL FEATURES

5Press ENTER.

The four-digit code set for the selected component appears in the display window.

Note

0000 appears in the display window if no code has been set.

6Press the numeric buttons to enter the four-digit remote control code for the component you want to use.

For a complete list of available remote control codes, refer to “LIST OF REMOTE CONTROL CODES” at the end of this manual.

STEREO MUSIC ENTERTAIN MOVIE

1 2 3 4

THX	STANDARD	SELECT EXTD SUR.
5	6	7	8
1	MEMORY 2	A	SPEAKERS B
9	0	+10	ENT.

7Press ENTER to set the number.

OK appears in the display window if setting was successful.

NG appears in the display window if the setting was unsuccessful. In this case, start over from step 3.

y

If you continuously want to set up another code for another component, press the input selector button or

SELECT k / n to select the component and then repeat steps 4 through 6.

8Press LEARN again to exit from the setup mode.

LEARN

OPERATION ADVANCED

English

99