Toshiba B-570-QQ owner manual Auto Ribbon Saving Mode

10. GENERAL MAINTENANCE

EM1-33035

10.4 Threshold Setting

■Threshold setting procedure (For firmware version 2.5 or earlier)

1Turn the power on.

2Load the pre-printed label. (Any position)

3 Press the [PAUSE] key once.

4 Hold down the [PAUSE] key for more than 3 seconds and it will begin to feed. After it has fed the 2 label, release the [PAUSE] key.

5 Press the [RESTART] key for ON LINE mode.

6 Threshold setting is now completed.

NOTES: 1. If the [PAUSE] key is not held down for more than 3 seconds in PAUSE mode the threshold will not be set.

2.If the [PAUSE] key is released before 2 labels have been issued the setting may not be correct and will have to be re-set.

10.5Auto Ribbon Saving Mode

Auto ribbon saving function is activated when it is selected by DIP switch (Refer to page 4-1) and no print area extends more than 20 mm.

NOTE: According to the relation between the outer diameter of rewound ribbon and print speed, ribbon loss per saving varies as follows:

Print speed	Ribbon loss
3"/sec.	Approx. 5 mm
5"/sec.	Approx. 8 mm
8"/sec.	Approx. 17 mm

10-5