Omega Vehicle Security FPU5-MT-220 RUNNING Display Mode, The RPM Mode, Pumping in the RPM Mode

6	Operating the Pump Motor in the
	RUNNING Display Mode

6.1 The RPM Mode

Figure 6-1 shows the overall block diagram of the RPM Mode in the RUNNING Display Mode.

STOPPED

DISPLAY

MODE

START

STOP

	CURRENT	OR	TUBE ID SETTING
TUBE ID	TUBE ID		TO BE USED IN
	SETTING		PUMPING

	CURRENT		RPM SETTING
RPM	RPM	OR	TO BE USED IN
	SETTING		PUMPING

(Refer to Section 5.5)

CALIBRATE

(Optional)

ACTUAL	RUNNING	START
RPM	DISPLAY	STOP
VALUE	MODE

Figure 6-1. Block Diagram: Pumping in the RPM Mode

In the RPM Mode, you pump fluid at a certain motor speed, without setting the amount of time you pump or the volume you dispense. The pump motor measures the time of pumping and volume of fluid dispensed but ignores the TIME and TOTAL VOLUME settings.

6.1.1 Pumping in the RPM Mode

To pump fluid in the RPM Mode, do the following:

1.Set up the pump motor for pumping, according to Chapter 3.

2.Toggle the ON/OFF switch to turn on the unit’s power. The display is in the STOPPED Display Mode. Refer to Figure 6-1.

3.Either set the tube ID for the tube you are using (following Section 5.3) or calibrate the tubing (following Section 5.5) before continuing.

4.Press the RPM key. The display flashes the current RPM setting (xxx rpm).

RPM

Display shows

xxx rpm

ACTION

Displays current

RPM setting

6-1