|
| Table | FLOW RATE MODE | |
| KEY | DISPLAY | ACTION TAKEN | |
|
|
| SHOWS | AND PROCEDURE |
|
|
|
|
|
|
|
|
| Pump motor’s power |
| ON/OFF Switch | XXX mL/min |
| |
|
|
| or | NOTE: if you turn off the pump motor’s power, the pump stops |
|
|
| XXX L/min | running. |
|
|
|
| To continue pumping, turn on the unit’s power. The display |
|
|
|
| returns to the STOPPED Display Mode and shows the current |
|
|
|
| FLOW RATE setting. The accumulated time of pumping and |
|
|
|
| volume dispensed is reset to zero. Then press the START/STOP |
|
|
|
| key . |
|
|
|
|
|
|
|
| XXX mL/min | Pump(s) starts; press again pump(s) stops |
|
|
|
| |
|
| START |
| |
|
| STOP | or | To start pumping at this setting, press the START/STOP key. |
|
|
| XXX L/min | The display enters the RUNNING Display Mode, and the fluid |
|
|
|
| begins to dispense. |
|
|
|
|
|
|
|
|
| LEDs indicate new pump direction |
|
|
| Must STOP first! |
|
| INLET |
|
| |
| SELECT |
|
| To select the other inlet and reverse the direction of pumping: |
|
|
|
| |
|
|
|
| |
|
|
|
| 1. Press the START/STOP key. The display returns to the |
|
|
|
| STOPPED Display Mode. |
2.Press the INLET SELECT key to reverse the direction of pumping.
3.Press the START/STOP key again to resume pumping.
4.For detailed instructions on “Defining the Direction of Pumping, refer to Section 5.2.
|
| STOP to Prime... | Pumps fluid at current flow rate |
| PRIME | setting as long as the key is pressed | |
|
| ||
|
|
|
|
To prime a tube:
1.Press the START/STOP key to stop the pump. The display returns to the STOPPED Display Mode.
2.Press and hold down the PRIME key to prime the tube.
3.Press the START/STOP key again to resume pumping.
4.For detailed instructions on “Priming a Tube”, refer to Section 5.4.
xxx °C | Display alternates when pressed, °C then °F |
TEMP
NOTE: The TEMP key functions the same whether the pump is stopped or running. Refer to Section 5.6.
xxx rpm | Displays actual RPM |
RPM
Press the RPM key. The display flashes the actual pump motor speed (xxx rpm).
