NTI AUDIO/HD VIDEO MATRIX SWITCH
Output Names
From the Administration menu, the Video or Audio Output Names page can be displayed. (Selected separately from the menu.) These pages enable the Administrator to change the names of the output ports displayed on the Switch page. To change an Output Name, enter the name of the port for the desired output port number, and press "Save".
Note: Only the changes to the port directly to the left of the Save button will be saved. All other changes to ports without pressing the port's respective Save button will be discarded. All port names must be no more than 16 characters in length and only alphanumeric characters may be used.
Figure 15- Web interface Output Names page
Scan Mode
From the Administration menu the "Outputs Scan Mode Settings" page can be displayed. This page shows a table with all outputs, the status of Scan Mode for each, and edit boxes for dwell time settings (in seconds) for each output. Each setting can be edited with a value from
If Scan Mode is disabled for a specific output, then the video to that output will only change as decided by the administrator.
To change Scan Mode from "Off" to "On", simply enter a dwell time value in a box under "Dwell Time" for any Output and press "Apply". Only those boxes with a value of 0 will indicate Scan Mode is "Off" for the respective output.
Scan Mode dwell time settings can also be configured through the LCD menu (page 7), Telnet commands (page 14), or through the RS232 Command Protocol (page 10).
Press "Clear All" to set all output scan mode settings to "Off".
For more on Scan Mode, see page 9.
Figure 16- Web interface Scan Mode page
21
