Network Technologies SM-8X4-HDA Telnet Interface, Telnet 192.168.1.1, Command Reply Description

NTI AUDIO/HD VIDEO MATRIX SWITCH

Telnet Interface

The Telnet Interface enables the user to control the switch using telnet client through an Ethernet connection. The telnet server listens on port 2000. To access the telnet interface, using the current IP address type the following in a command shell:

telnet 192.168.1.1 2000

The VEEMUX-A will prompt the user for a password. The user must enter the password followed by <Enter>.

The factory default password is "admin".

With a proper password sent the VEEMUX-A will respond with:

Password Successful

Connection Established

The following commands are now available:

Command	Reply	Description
H(elp) or	Displays the list of commands	Help
h(elp)
CS nn,mm	*<CR>	Connect One Output nn To Input mm
CA nn	*<CR>	Connect All Outputs To Input nn
RO nn	*<CR>mm<CR>	Read Connection For Output.
		Returns the number of the input mm connected to output nn
CC nn	*<CR>nn<CR>	Save Matrix Connections Into Memory Bank nn
		nn should be between 00 and 99
RC nn	*<CR>nn<CR>	Restore Matrix Connections From Memory Bank nn
		nn should be between 00 and 99
CB nn	*<CR>	Change baud rate of serial line, nn=12(00),24(00),48(00),96(00)
		Factory default is 9600.
RV 00	*<CR>string<CR>	Read NTI Version String
RU	*<CR>nn,mm<CR>	Read Unit Size
		Returns the number of inputs mm and the number of outputs mm
RS	*<CR>	Reset Unit
AS nn,mm	*<CR>	Connect audio input mm to output mm
AA nn	*<CR>	Connect audio input nn to all outputs
AO nn	*<CR>nn<CR>	Read audio connection for output nn
AM nn,mu	*<CR>	Set mute state for output nn
		mu(te State) = (00=UNMUTE, 01=MUTE)
AV nn,vv	*<CR>	Set volume level for output nn
		vv is a value between 00 to 99 (see chart page 12)
		Read mute, volume for output nn
AR nn	*<CR>MU,VV<CR>	MU is 00 if the port is UNMUTED, MU is 01 if the port is MUTED.
		VV is a value between 00 to 99 (see chart page 12)
		Set value of Scan Mode dwell time (see page 9) for specific Output
Ss nn,dwt	*<CR>	(nn)
		dwt = 000-255 (seconds) 000= disable Scan Mode
Gs nn	*<CR>	Read set Scan Mode dwell time value (dwt) for specific Output (nn)
	dwt<CR>	in seconds (see also "Scan Mode" on page 9)
Sa nn,mm	*<CR>	Set scan list of individual output nn to all inputs mm

14