Customizing the Function Settings
The symbols that might appear next to each listed wireless network in the network list are as follows:
Category | Icon | Definition |
Connected |
| When the BD player is |
|
| turned on, it will connect |
|
| to the wireless network |
|
| displaying this symbol. |
|
| Typically, this is the last |
|
| wireless network connected |
|
| before powering down. |
|
|
|
Saved |
| The wireless network prop- |
|
| erties have been saved in |
|
| the BD player’s memory. |
Wireless Security |
| The wireless network data |
|
| is not encrypted. |
|
|
|
|
| The wireless network data |
|
| is encrypted; a ‘security key’ |
|
| must be entered so that the |
|
| BD player can share data |
|
| over the network. |
|
|
|
|
| The wireless network data |
|
| is encrypted; the encryption |
|
| scheme is not supported by |
|
| the BD player. |
|
|
|
Wireless Protocol | a | The wireless network sup- |
| ports 802.11a | |
|
|
bThe wireless network sup- ports 802.11b
gThe wireless network sup- ports 802.11g
nThe wireless network sup- ports 802.11n
Signal Strength | Strong Signal |
Good Signal
Medium Signal
Weak Signal
No Signal
I.Connection to the wireless Network which you select
1.Press 
/ 
to select Wireless, then press OK to confirm. the following screen will appear.
Network List |
WiFi Protected Setup (WPS) |
Manual |
IP Settings |
2.Press 
/ 
to select Network List, then press OK. A list of existing wireless networks near the BD player will appear (It may take several seconds for this list to be created). For example:
|
| Network List | |
|
|
|
|
| WiFi a |
| |
| WiFi b g n | Panda | |
| WiFi a | dlink_media | |
| WiFi b g | NTGR 11g | |
| WiFi b g | Airport_SN | |
|
|
|
|
3.Press 
/ 
to select the desired wireless network, and press OK to confirm.
a. If the BD player is connected to an Unencrypted Wireless Network, a menu similar to the following will
appear:
WiFi-me
Connect WPS Pin Delete Cancel
4.Press 
/ 
to highlight Connect, and press OK. If the
wireless network is functioning, 
icon and a message “Connection to XXX...Success” will appear on the TV.
5.Press OK to close the message. The BD disc player is now connected to the network. From now on, when you turn on the player, it will automatically connect to the network; there is no need to repeat these steps again.
Note: If you do not see this message, the BD player was not able to connect to the network.
b. If the BD player is connected to an Encrypted Wireless Network, a menu similar to the following will appear:
Password
Connect WPS Pin Cancel
Press ENTER to open keyboard
4.Press ENTER to activate the 
/ 
/ 
/ 
to highlight the desired letter on the keyboard, and then pressing OK. (If you make a mistake, use the
backspace 
key to erase the mistake.)
FUNCTION SETUP
29
