Toshiba D-R400 owner manual To stop the timer recording in process, Each error number means

TIMER RECORDING

Checking, canceling, or correcting the timer programming information

1)Press [I/y ON/STANDBY].

2)Press [TIMER PROG.].

3)Check the information on the list you want to edit.

Timer Programming

JAN/ 2/07 12:00 AM L1		SP
SP (1:00)		MON JAN/01 10:00AM
Date	Start	End	L1/L2
JAN/02	12:00AM	1:00AM	L1
	New Program

If the timer program did not complete correctly, the error number appears in the timer pro- gramming list.

Timer Programming

MON JAN/01 10:00AM

	Date	Start	End	L1/L2
E40	JAN/02	12:00AM	1:00AM	L1
		New Program

1/1

Each error number means:

Introduction

Connections

1/1

4-A) To delete the timer program:

1 Use [K / L] to select the program you want to delete, then press [ENTER].

2 Use [K / L] to select “Delete”, then press [ENTER].

Selection menu will appear.

3 Use [K / L] to select “Yes”, then press [ENTER].

4-B) To correct the timer program:

1 Use [K / L] to select the program you want to correct, then press [ENTER].

2 Use [K / L] to select “Program Change”, then press [ENTER].

3 Correct the timer program by using [K/ L/ {/ B], then press [ENTER].

5) Press [TIMER PROG.] to exit.

E1-22	Recording error other	E40
E37-39	than below
E23-24	Unrecordable disc
E25-28	Copy prohibited program
E29	Disc protected	E41
E30	Disc full	E42
E31-32	Already 99 titles	E43
	recorded
E33	Already 999 chapters	E44
	recorded
E34	No space for Control	E45
	information
E35	PCA full *1	E46
E36	Already finalized
	video format disc

Some portion has not been recorded because of program overlapping. Recording did not start at the start time.

Power failed

No disc when recording

Already 49 titles recorded

Already 254 chapters recorded

Copy prohibited program

It is impossible to record additionally on a disc recorded by other units when setting “Make Recording Compatible” to “OFF”.

Basic Setup

Disc Management

Recording

6) Press [I/y ON/STANDBY] to return to the timer

standby mode.

To stop the timer recording in process

Press [STOP C] on the front panel of the unit. [STOP C] on the remote control is not effective.

Note

•Press [TIMER PROG.] to check the timer recording in progress.

When the timer recording is proceeding, that program will be highlighted with red. In this case, you cannot select any other program.

•A program with the error number is grayed in the timer programming list.

•Once the timer programming list with error line(s) is displayed, or after canceling and setting again the timer standby mode, the program line(s) with error will be cleared.

*1 PCA is a disc's space reserved for recording test.

Playback

Editing

Function Setup

Others

EN 39

E7E7AUD_EN.indb 39 2007/01/29 19:03:58