Toshiba DKT3001/2001 manual To change your Pass Code, To use the Call Forward button sequence

Advanced Operation

Call Forward

Some Call Forward features require a Pass Code entry. Use the following procedure to change your Pass Code.

➤To change your Pass Code

➤Dial ￿￿￿￿￿+ Ext. No. + old Pass Code (1~15 digits) + ￿￿+ new Pass Code (1~15 digits) + ￿.

➤To use the Call Forward button sequence

➤Use the procedure for dialing from your telephone, then use the Button Sequence (see Table 2) for the desired feature.

Some features require additional input, such as:

•Destination – If the destination is an outside number, press ￿￿after entering the destination. The CTX accepts destination numbers of up to 32 digits.

•Timer – This is a two digit entry representing how long (8 to 160 seconds) your telephone should ring before forwarding the call. If you enter one digit, you must press ￿￿after entering the single digit.

•Pass Code – A four-digit code established by system programming to prevent unauthorized changes. The code applies to the station to be forwarded; not to the station entering the code.

Note Also, in the following table, (Tone) means that a confirmation tone will play at that point in the sequence.

Table 2	Call Forward Procedure
Feature		Button Sequence
Call Forward Any Call (Internal and Incoming Line)
All Call		(Tone) + Destination No. (Tone)
Busy		(Tone) + Dest. No. (Tone)
No Answer		(Tone) + Dest. No. (Tone) + Timer + ￿
Busy No Answer		+ Dest. No. + Timer + ￿
Cancel		￿￿￿￿￿(Tone)

22 Strata CTX DKT3001/2001 Digital Single Line Telephone 01/02