TROUBLESHOOTING GUIDE
Should any problem occur with the set, make the following simple tests to determine whether or not servicing is required.
PROBLEM | SOLUTION | |
|
|
|
The handset battery | • The charging contacts of the handset and base are not | |
does not charge. | clean. | |
| →Clean them with a dry cloth. | |
| • The battery connector is not connected with correct | |
| polarity. | |
| →Install the battery correctly. | |
| • The battery is several years old. | |
| →Replace with a new battery. | |
Battery becomes low | • The battery was not fully charged at the initial charging. | |
quickly. | →Charge the battery for 12 to 16 hours without any | |
| interruption. | |
| • The battery is several years old. | |
| →Replace with a new battery. | |
|
|
|
Can not make or | • The AC adaptor of the base unit is disconnected. | |
receive calls. | →Plug the AC adaptor into the base unit and the AC | |
Can not hear the dial | 120V outlet. | |
tone. | • The battery is low. | |
| →Place the handset on the base unit to recharge. | |
| • Telephone line cord is disconnected. | |
| →Check both ends of the telephone jack. | |
| • The previous call was not disconnected. | |
| →Press TALK to disconnect the line. | |
| • Trouble with the telephone line. | |
| →Check an extension line. | |
| • Outlet used is controlled by a wall switch in its OFF | |
| position. | |
| →Relocate to another outlet. | |
| • The handset is too far from the base unit. | |
| →Bring the handset near the base unit. | |
| • Dial setting needs to be changed. | |
| →Press and hold FLASH then choose the appropriate | |
| setting. | |
TALK/BATT LOW | • The battery is low. | |
LED blinks in the | →Recharge the battery. | |
standby mode. |
|
|
|
|
|
17
