PROBLEM | SOLUTION |
|
|
The handset does | • The handset is located too far away from the base or the |
not ring or receive a | battery has been discharged. |
page. | →Return the handset to charge when your call is |
| finished. |
| • The digital security code is changed. |
| →Remove the handset from the base unit and press |
| and hold PAGE . While the handset is emitting, return |
| the handset to the base unit. |
| • The battery is low. |
| →Place the handset on the base unit to recharge. |
CHARGE LED does | • The charging contacts of the handset and the base are |
not light when the | not clean. |
handset is placed on | →Clean them with a dry cloth. |
the base. | • The AC adaptor of the base unit is disconnected. |
| →Plug the AC adaptor firmly into the base unit and AC |
| 120V outlet. |
| • The handset is not on the base. |
| →Place the handset on the base properly |
Noise or | • The handset is too far from the base unit. |
interference. | →Bring the handset near the base unit. |
| • The battery is low. |
| →Place the handset on the base unit to recharge. |
| • The base unit is located in a place with high |
| interference. |
| →Relocate to another outlet. |
| • Interference from TV, Microwave oven, Computer and |
| electrical appliances. |
| →Press CH to select a clearer channel, or relocate the |
| base unit. |
| • Excessive line noise. |
| →Check with another telephone. |
| • The volume control is set too high. |
| →Reduce volume to lower setting. |
| • The base antenna is not in a vertical position. |
| →Lift the antenna to a vertical position. |
The unit does not | • The phone needs to be reset. |
operate properly. | →Disconnect the AC adaptor and reconnect it after a |
| few seconds. |
When the handset is | • This is normal. |
returned to the base | →It may be prevented by changing the volume setting |
unit with the volume | to Medium or Low before returning the handset to the |
level set at High, a | base unit. |
momentary squeal |
|
or howling sound |
|
may sometimes be |
|
heard. |
|
|
|
