Speciﬁcation | Toshiba HD-EP30KE, HD-EP30KB specification

Speciﬁcation

Power requirement

35.0W

Power supply

220 - 240V AC 50/60Hz

Mass

3.3kg

External dimension

Width 430 x Height 59.5 x Depth 327mm

Signal system

Standard PAL/NTSC colour system

Laser Semiconductor laser

Wavelength: 405nm/650nm/780nm

VIDEO output

1.0Vp-p (75Ω), Sync signal negative, Pin jack x 1 system

Component output (Y, PB, PR)

Y output (green), 1.0Vp-p (75Ω), Pin jack x 1 system

PB, PR output (blue, red), 0.7Vp-p (75Ω), Pin jack x 1 system each

Analog audio output

2.0V (rms), 2.2kΩ or below, pin jack (L, R) x 1 system

Digital audio output (BITSTREAM/PCM jack) Optical connector x 1 system

LAN port 100BASE-TX/10BASE-T x 1

Extension port 1 system

HDMI output

19 pin, Type A connector

Remote control

Wireless remote control (SE-R0288)

Operating conditions

Temperature: 41°F ~ 95°F (5°C ~ 35°C)

Position: Horizontal

Clock accuracy

Quartz (monthly deviation: approximately ±30 seconds)

•Designs and speciﬁcations are subject to change without notice.

•This model may not be compatible with features and/or speciﬁcations that may be added in the future.

•The illustrations and screens described in this manual may be exaggerated or simpliﬁed for easy recognition and may be slightly different from the actual unit.

37

HD-EP30KE_Eng.indd 37

07.9.3 2:02:06 PM

Image 37

Toshiba HD-EP30KE, HD-EP30KB owner manual Speciﬁcation

Contents

HD-EP30KB HD-EP30KE Result in hazardous radiation exposure This HD DVD player employs a Laser System Following information is only for EU-member states Location of the required label Important Safety Instructions Precautions Moisture condensation occurs during the following cases Do not use the unit when moisture condensation may occur Table of contents Disc compatibility FeaturesDisc Speciﬁcation HD output jacks Important notes about HD DVDCertain system requirements Customer support Front panel Index to parts and controlsRear panel Display Remote control Remote control AccessoriesSupplied accessories Loading batteries Why Hdmi connection is most recommended? Resolution and connectionsPreparation Proceed the following steps to set the player ready Via Hdmi input Connecting to a TVVia component video input Via Video yellow input Via Hdmi output Connecting to audio systemVia optical digital audio output Via analog audio output LAN connection Power connection Setting up the player Powering onLanguage Time Press / to select Picture, then press OK ResolutionFor best viewing of ﬁlm movie material 24p output Press / to select Audio, then press OK Audio output Enter the proxy server address when your provider To adjust the player’s clock via the network time protocolRequires proxy setting Ethernet Network Speed Cookie Setting Playing a disc PlayingPlayback starts If playback does not start, press Play To stop playback To pause playbackTo resume playback from the location last stopped To change playback speed To select the sound To select subtitlesTo select the camera angle During playback, press Subtitle To check the current status To locate a positionTo play repeatedly HD DVD playing options in the future Requirements for HD DVD discs/Web-enabled network contentC/D buttons Cursor controls ADV Output sound conversion table During stop, press Setup Customizing the function settingsGroup Setting Disc Details Picture Settings Language Audio Subtitle Language How to select a languageAudio Language On Screen Language General Ethernet Enable Hdmi Remote Controller SoundMaintenance Initialize Update Firmware Symptom Remedy Before calling service personnel Speciﬁcation Memo Memo Information on Customer Support