(8. 4) Changing OSD (On Screen Display) output

1Move the ÒÓ to OSD OUTPUT by pushing the [MENU UP], [MENU DOWN] buttons.

2Select ALL ON or DVI or SDI by pushing the [DATA UP], [DATA DOWN] buttons.

[DATA UP]

ALL ON DVI SDI

[DATA DOWN]

¥If set to ALL ON, display will be shown on monitor TVs that are compatible with DVI-D input or 3G/HD-SDI input.

¥If set to DVI, display will be shown only on DVI-D output.

¥If set to SDI, display will be shown only on 3G/HD-SDI output.

If you do not select the same OSD output as the type of monitor that is connected, the display may disappear. If this happens, turn the power off and then on, then use the procedure in 7.2 (11) "Returning to factory settings" to reset the default settings. After that, reset the other settings.

(8. 5) Change of vertical inversion setting

1Move the ÒÓ to FLIP by pushing the [MENU UP], [MENU DOWN] buttons.

2Select ON (Vertical inversion image appears.) or OFF by pushing the [DATA UP], [DATA DOWN] buttons.

(8. 6) Change of horizontal inversion setting

1Move the ÒÓ to MIRROR by pushing the [MENU UP], [MENU DOWN] buttons.

2Select ON (Horizontal inversion image appears.) or OFF by pushing the [DATA UP], [DATA DOWN] buttons.

(8. 7) Switching of inversion mode display

1Move the ÒÓ to STATUS DISP by pushing the [MENU UP], [MENU DOWN] buttons.

2Select ON or OFF by pushing the [DATA UP]-[DATA DOWN] buttons.

When ON is set, the setting status of vertical/horizontal inversion is displayed in the lower right part of the screen.

FáááVertical inversion is effective.

MáááHorizontal inversion is effective.

FM

(8. 8) Change of binning setting

This is a function for increasing the sensitivity by combining (grouping) a matrix of horizontal and vertical pixels into a single group.

1Move the ÒÓ to BINNING by pushing the [MENU UP], [MENU DOWN] buttons.

2Select ON or OFF by pushing the [DATA UP]-[DATA DOWN] buttons.

Note:

Turning the binning setting ON (effective) lowers the resolution.

31