Alignment sticker

Notes:

Alignment sticker

The included screws and anchors are used to install the

camera to a solid surface. (e.g. concrete) If installing on loose

 

or thin material surfaces , use the appropriate anchors (not

 

included) with the screws.

 

Generally the camera turns a built-in microphone in the

direction of object.

Install the camera securely.

Mounting the camera to a solid surface

(1)Attach the Alignment Sticker to the surface.

(2)Drill three pilot holes (Ø0.28inch×1.57inches(D) (Ø7mm×40mm(D))) through the three circles on the sticker.

(3)Hammer the supplied plastic anchors into the holes.

(4)Drill a hole (Ø1.0inch(Ø25mm)) behind the camera

body on the sticker, and lead the cables through this hole.

(5)Align the three mounting holes of the Camera with the three plastic anchors; insert the included three screws to the corresponding holes and tighten them with a driver.

Cable installation

If possible, lead all cables behind the camera body through a wall or ceiling. If this is not possible, use the knock out on the camera cover to route the cables through the side.

NOTE

Installation should be done only by qualified personnel and conform to all local codes.

Install this camera on a firm and solid part of the ceiling or wall.

If installed improperly or on a weak surface, the camera could fall causing injury and damage.

Use Category (Cat) 5 or higher cable.

14

Page 14
Image 14
Toshiba IK-WD14A quick start Mounting the camera to a solid surface, Cable installation