Hardware, Utilities and Options

Installing a memory module

To install a memory module, follow the steps as detailed below:

1.Shut down the computer - make sure the Power indicator is off (refer to the Turning off the power section in Chapter 1, Getting Started if required).

2.Remove the AC adaptor and all cables and peripherals connected to the computer.

3.Close the display panel.

4.Turn the computer upside down and remove the battery pack (refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, if required).

5.Loosen three screws securing the memory module cover in place - please note that those screws are attached to the cover in order to prevent them from being lost.

Use a point size 0 Phillips screwdriver.

6. Slide your fingernail or a thin object under the cover and lift it off.

2

1

1. Memory module cover

2. Screws

Figure 3-4 Removing the memory module cover

User’s Manual

3-21