User’s Manual 4-29
Operating Basics
Region selection
Telecommunication regulations vary from one region to another, so you will
need to make sure the internal modem’s settings are correct for the region
in which it will be used.
To select a region, follow the steps as detailed below:
1. Click Start -> Control Panel. Select Large icons or Small icons in
View by.
2. Click Phone and Modem.
3. In the Dialing Rules tab, select a location from the Locations list and
then click Edit.
4. In the General tab, select a country or region from the Country/region
list and click OK.
5. Click OK in the Phone and Modem window.
Connecting the modular cable
To connect the modem's modular cable, follow the steps as detailed below:
1. Plug the end of the modular cable into the computer's modem jack.
Modem functions cannot be used in models which are not equipped with a
modem.
The built-in modem can be used only in specified countries and regions.
Using the modem in an area not specified for use may cause a system
failure. Check the specified areas carefully before using it.
When you open Phone and Modem for the first time, a dialog box will be
displayed, prompting you to specify the location from which you will be
dialing.
Please check whether the region you are going to select is supported by
this computer. If you select a region that is not supported, the local setting
of the modem will default to the United States.
■Connection to any communication line other than an analog phone line
could cause a computer system failure.
■Connect the built-in modem only to ordinary analog phone lines.
■Never connect the built-in modem to a digital line (ISDN).
■Never connect the built-in modem to the digital connector on a
public telephone or to a digital private branch exchange (PBX).
■Never connect the built-in modem to a key telephone system for
residences or offices.
■Avoid using your computer modem with the telephone cable connected
during an electrical storm. There may be a remote risk of electric shock
from lightning.